Adapted Actions Taken at Too Low Shotcrete Quality
A tunnel contract specified quality parameters such as: thickness, compressive strength, adhesive strength, bending tensile strength and residual bending tensile strength for fibre reinforced...
Open Channels in Fractures Maintained by Deposition and Erosion of Colloids
Colloids initially suspended in the water in fractures can deposit onto the fracture surfaces, and will partially or fully clog the fracture. The amount of clogging will depend on whether...
Geometric Analyses of Alternative Models of Faulting at Yucca Mountain, Nevada
Realistic cross section tectonic models must be retrodeformable to geologically reasonable pre-deformation states. Furthermore, it must be shown that geologic structures depicted on cross...
Micromechanics of Deformation in Topopah Spring Tuff, Yucca Mountain, Nevada
Samples of Topopah Spring tuff from Yucca Mountain, Nevada have been tested and analyzed. Laboratory tests conducted include standard uniaxial and triaxial compression tests, and special...
A Generalized Three Invariants Cap Model and its Numerical Implementation to Study Soil-Foundation Interaction
This paper presents a modified cap model that is capable of characterizing cyclic stress-strain behavior of soils and describing variation of shear strength along various stress paths...
Subsidence Properties of Holocene Sediments: S. La.
As part of a comprehensive USGS-sponsored study of processes that drive subsidence and wetland loss in south Louisiana, two continuously cored deep borings (60 m and 72 m) were acquired...
Dredged Material Filled Geotextile Containers
Design and construction of geotextile containers hydraulically and mechanically filled with a variety of dredged material types has gained popularity in the past few years because of their...
Calculation of Longshore Sediment Transport on Abrasive Coasts with Attached Pebble Beaches
The calculation scheme and expressions are suggested for flow power of universal nature which expresses the flow capacity such that the sediment transport is proportional to the flow longitudinal...
Effect of Moisture and Bulk Density Sampling on Neutron Moisture Gauge Calibration
Three moisture and bulk density sampling methods were evaluated for use in neutron gauge calibration. Each of the methods was comprised of a single core or portions of a core taken during...
Rheometry of Natural Sediment Slurries
Recent experimental analyses of natural sediment slurries yield diverse results yet exhibit broad commonality of rheological responses under a range of conditions and shear rates. Results...
New Canadian Provisions Related to the Design of Composite Beams
In this paper, the new provisions in CAN/CSA-S16.1-M89 for the design of composite beams, together with reasons for changes, are discussed. Some of the new provisions reflect results of...
Shear Connection in Composite Beams
This paper considers the influence of the shape of the deck profile on the shear connection of composite beams. It was found that the existing strength reduction factor can be unconservative...
Modern Design Concept for Composite Slabs with Ductile Behaviour
Numerous tests with different types of composite slabs have been carried out in the laboratory for constructional engineering of the University of Kaiserslautern, Germany in order to determine...
Design of Shear Connectors in Composite Bridge Beams
A new approach is described for the design of stud shear connectors, in composite steel and concrete beams that are subjected to vehicular loads, which allows for the interaction between...
Design of Composite Slabs for Vertical Shear
Three major modes of failure should be considered in the design of the positive moment regions of composite slabs incorporating profiled steel sheeting, viz.: flexure, longitudinal slip...
Investigation of Corners and Joints Applied to a Steel-Concrete Composite Caisson
We have developed a caisson composed of steel-concrete composite slabs and steel structures, which we call a `Hybrid Caisson.' We studied the structural principles and usability of the...
Development of Composite Slab with Truss-Typed Shear Connectors
This paper describes the results of the test on a steel-concrete composite slab with truss-typed shear connectors. This composite slab was recently developed. A series of tests were conducted...
Connection of Beam Flange to Concrete-Filled Tubular Column
Research has been carried out on a frame composed of a concrete-filled steel tubular column and H-shaped steel beam with the aim of developing a reasonable connection method. The proposed...
Thin Walled Circular Concrete Filled Steel Tubular Columns
The thin walled steel tube filled with high strength concrete delivers the economies of a concrete column with the speed of construction and the constructability of a steel column resulting...
Strength and Stiffness Behavior of Composite Steel Grid Decks
This paper briefly discusses the historical development of composite steel grid decks. The static and fatigue behavior under bending of filled and unfilled steel grid decks (exodermic)...
Return to search