Aerodynamic Methods for Mitigating Wind-Induced Building Motions
Excessive wind-induced motions of tall buildings most frequently result from vortex shedding induced across-wind oscillations. This form of excitation is most pronounced for relatively...
Full-Scale Measurement on Chiba Port Tower
Chiba Port Tower is a tall tower, 125m high, with a rhombus shaped plan. All of the surfaces are covered with half mirror glass. On the top of the tower, a 'Tuned Mass Damper'...
Unsteady Aeroelastic Base Moments on a High-Rise Building
To consider aeroelastic instabilities of prismatic structures in winds, i.e., vortex induced vibrations or galloping oscillations, unsteady aeroelastic forces must be investigated as the...
Inelastic Performance of Single-Story Masonry Shear Walls
Twenty-two story-height reinforced masonry shear walls have been tested to examine the influence of the applied axial stress, and the amount of vertical and horizontal reinforcement on...
Use of Experimental Data to Develop Probable Behavior
The intent of this paper is to present results of research that studies the performance of the University of Colorado walls tested by Professor Benson Shing. These walls would be classified...
Vibration Control Damper Using Sloshing of Water
The objective of this study is to develop a method of reducing wind-induced vibration of long-period structures utilizing sloshing of water in tanks added to the upper part of the structures....
Bond and Dowel Action of a Main Bar in a RC Beam
The bond and dowel action are analytically treated independently on each other in most cases. The bond behavior may be, however, much affected by the dowel action in structural members....
ATC 14: A Methodology for the Seismic Evaluation of Existing Buildings
A new method for evaluating the seismic resistance of existing buildings has been developed based on the historic performance of buildings in past major earthquakes. This methodology identifies...
Comparison of Slitted and Non-Slitted R. C. Shear Walls With Boundary Elements Under Horizontal Forces
This paper compares the differences of aseismic behaviours between slitted and non-slitted shear walls under horizontal forces. There are 5 specimens for slitted shear walls and another...
The New 1988 SEAOC Blue Book and 1988 UBC Overview of Lateral Force Section
This paper presents an overview of the lateral force section of the new seismic design provisions of the 1988 edition of the Uniform Building Code (ICBO, 1988), and the 1988 Blue Book...
Equating Dynamic Analysis to Static Code Provisions
Building codes generally prescribe seismic design provisions that include a static lateral force procedure that can easily be combined with the gravity loads to design the structural elements....
Response of Concrete Buildings to Lateral Forces
ACI-ASCE Committee 442 (Response of Concrete Buildings to Lateral Forces) has just issued its report (ACI-ASCE 442 1988a). In that Report, the performance of reinforced concrete buildings...
Load Transfer in Deep Foundations Under Repeated Axial Loading
An analysis is presented of changes in axial load transfer for deep foundations under repeated loading, compared with static uplift and compression loading. Existing load test data demonstrate...
Numerical Modeling of Interface Behavior for Drilled Shaft Foundations Under Generalized Loading
To evaluate soil-foundation interaction numerically, an isoparametric thin layer element is used within a 3-D, material nonlinear, general purpose geotechnical analysis system developed...
Analysis of Pile Load Tests at Lock and Dam 26
This is a summary of the results collected during the extensive load test program performed by the U.S. Army Engineer District, St. Louis, during the construction of the new Lock and Dam...
Interpretation of Load Tests on Drilled Shafts?Part 1: Axial Compression
Existing interpretation methods for axial compression load tests are reviewed critically, and a qualitative and quantitative comparison is made for selected methods. A simplified method,...
Interpretation of Load Tests on Drilled Shafts?Part 2: Axial Uplift
Existing interpretation methods for axial uplift load tests are reviewed critically, and a qualitative and quantitative comparison is made for selected methods. A new method, which fulfills...
Issues in Evaluating Combined Repeated Loading of Deep Foundations
The capacity and load/displacement response of deep foundations subjected to combined modes of repeated loading can be significantly different from the response under single (axial or...
Sensitivity Study of the Cyclic Axial Capacity of a Single Pile
Evaluation of the axial capacity of an offshore pile subjected to a severe North Sea storm is presented. Effects of using different degradation criteria, upper and lower bound interaction...
Axial Capacity of Pressure-Injected Piles: A Cavity Expansion Model
The application of cavity expansion theory to the development of a mathematical model for predicting the ultimate axial capacity of pressure-injected piles in cohesionless soils is presented....
Return to search