An Alternative Approach to Erosion Control and Mitigation
A case study is presented in which a sediment engineering investigation was conducted to determine the potential effects of a change in flow regulation on the channel downstream of a lake,...
Channel Entrenchment Along the Post Creek Cutoff in Southern Illinois
The Post Creek Cutoff was constructed in 1915 by the Cache River Drainage Commission to divert flow from the Upper Cache River to the Ohio River. The construction of the cutoff reduced...
Corps of Engineers' Mississippi River Sediment Studies
In conjunction with the 1838 U.S. Army Corps of Engineers hydrographic survey of the Mississippi River, CPT A. Talcott collected sediment samples in the passes 'to determine...
Critical Shear Stress of Armour Coat
The problem of the determination of the critical shear stress of the armour coat is important in sediment transport, river degradation and aggradation and flow discharge regulation. The...
Sediment Transport Model for Muddy Tidal Rivers
This paper describes the development and application of a one-dimensional mathematical model capable of simulating the changes to the cross-sections of a muddy tidal river over a time...
Implications of Deep Ocean Modelling on Coastal Sedimentation Prediction
The Harvard University Ocean Predictive Descriptive System is reviewed and recent results of mesoscale ocean prediction are presented for the Northeast Pacific and Gulf Stream Ring Stream...
Applications and Research in Sediment Delivery and Routing Models in the USDA-Forest Service
Sediment delivery and routing are important watershed management issues in the USDA-Forest Service. The relationship between forest management activities and stream morphology, resident...
An Overview of Computer Stream Sedimentation Models
This paper discuss some of the author's experience in computer modeling of stream sedimentation problems. Comparisons of twelve selected models developed and implemented in...
Integral Length Scale in Sediment-Suspending Flow
The Clauser integral length scale is an adequate scaling parameter for velocity defect profiles in clearwater and sediment-suspending flows in open channels. Velocity defect profiles plotted...
Areal Sampling Techniques
Three areal methods, commonly used for sampling the coarser surface layer of gravel-bed streams, are examined. An idealized sediment deposit, that consists of cubic particles and accounts...
Sediment Transport in Hyperconcentrated Flows in Sand-Bed Streams
This study advances the understanding of sediment transport of bed material discharge in sand bed streams through application of recently developed theoretical concepts related to the...
Estimating Velocity and Scour in River Bends
A one-dimensional, steady-state, stream tube model was used to simulate hydraulic characteristics at a cross section. This enabled computation of higher velocities on the outside and lower...
The Area of Scour Hole Around Bridge Piers
The study is focused on what parameters determine the area of scour hole around bridge piers. An analytical study based on momentum principle has been used to reveal the variables involved...
A Coastal Hard Rock Sediment Budget for the Inner Bristol Channel
The dominant input into the inter-tidal zone from the hard rocks bordering the inner Bristol Channel is clastic material. This is derived from coastal recession as a result of subaerial...
Field Measurement of Topography at a River Mouth
The authors have been measuring topography and cross section at the river mouth of the Nanakita River, in Japan. Changes of short-time scale, such as straightening of the river channel...
Flow Modeling in the Toutle River, Washington
In support of flow, suspended load, bed load, and bedform transport measurements, a quasi-three-dimensional river flow model was adapted to a reach extending from 260m upstream to 30m...
Limitations of Modeling High Concentration Streams
Following the 1980 eruption of Mount St. Helens, high sediment concentrations caused rapid deposition and increased flood hazards along the Cowlitz River. The Corps of Engineers developed...
Mechanics of Mud Flows in Curved Channels with Uneven Beds
Most natural debris flows move through paths that are curved and that have significant bed topography. Owing to the dependence of the mechanics of wet debris containing substantial amounts...
Comparison of Models for Single-thread Streams
A variety of two- and three-dimensional models for flow in curved channels and rivers have recently been made available for engineering use, and the question arises as to how sophisticated...
Selective Erosion: A Key Problem in Numerical Modelling of River-bed Changes
In capacity-controlled sediment transport of alluvial rivers the so-called 'hiding factor' determines the stability of the various grain-size fractions. The paper...
Return to search