Treatment, Reuse and Disposal of Drain Waters
Treatment, reuse and disposal options of agricultural drainage water present formidable technical problems. Various treatment technologies and disposal methods have been studied. Reuse...
Water Resources Infrastructure
Needs, Economics, and Financing
This proceedings,
The Bearing Capacity of Debris Flows
Debris flows are made of a cohesive muddy matrix in which large and heavy particles exist in suspension. To explain how these particles are maintained in suspension, several mechanisms...
Feasibility of Stormwater for Recharge in the Las Vegas Valley
Rapid growth in the Las Vegas Valley has increased the pressure on the limited water supply. The increased water demand has stimulated public interest in water conservation and the potential...
Predicting Stream Width and Bank Retreat
The width of streams is dependent on the flood flow discharge which varies from year to year, the bank material which varies from stream to stream and reach to reach, the sediment load...
Resistance Consisting of Both Viscous Force and Dispersive Force
A set of specially designed experiments have been carried for studying the resistance of a flow consisting of water and both fine and coarse particles. The viscous force caused by fine...
A Reservoir Yield Evaluation in an Arid Climate
Yield calculations rarely can be more accurate than roughly plus or minus twenty percent. The same uncertainty is dramatically greater in arid climates where the average annual runoff...
A Value Engineering/Risk Analysis Approach to Operation and Maintenance of Hydraulic Structures
Value engineering is an objective, systematic method for minimizing cost of a system. Risk analysis is a method of quantifying uncertainties or probabilities of possible economic loss,...
Stable Channel Analytical Design Method
The Flood-Control Channels Research Program is being conducted at the US Army Engineer Waterways Experiment Station to develop systematic methods for design of stable channels for small...
Can Erosion Control Meet Regulatory Standards?
An erosion control design method for rainfall/surface erosion is presented that enables the designer to determine design loads and the resulting erosion control requirements. Design loads...
Coronarization of the Autonomous Water pump
The conventional hydraulic pressure multiplier has been successfully used by Belgian technician Robert Houman (1986) to provide a dependable source of water supply to the NATO-base at...
Availability of Portland Cement
A general description of economic, technical, and environmental factors that affect the types of portland cement available is presented. Economic factors have had a major effect on balance...
Effects of Physicochemical Factors on Asphalt Aging
A new model for asphalt oxidative aging is presented. The model proposes that the kinetics of low temperature aging in the pavement temperature range is largely governed by physicochemical...
Laboratory Aging of Asphalt-Aggregate Mixtures
Aging may result in hardening (stiffening) of the mixture which will result in a change in performance of the mixture. This may be beneficial since a stiffer mixture will have improved...
Asphalt Age Hardening?Trends and Predictions
Pavement cracking is substantially related to the consistency of asphalt cement binders. The variation in hardness of binders is related primarily to asphalt characteristics, environment...
Asphalt Changes in Drum Dryer and Batch Operations
The study was designed to determine whether steam distillation of asphalt takes place in a drum dryer mixer by comparing changes induced by various laboratory conditioning (aging) techniques...
Three Tools for Design Test Bed Analysis
Three analytical tools are outlined for use in design test bed work focusing on the design/production interface. The tools are substitution analysis, coupling analysis, and value chain...
Effect of Fly Ash on the Microstructure and Durability of Concrete
The influence of fly ash on the microstructure and durability of concrete was investigated. It was found that the use of 50% fly ash in concrete reduced greatly its resistance to freezing-and-thawing...
Permeability Effects on the Sulfate Resistance of Concrete
A laboratory study was conducted to determine the effect of permeability on the sulfate resistance of concrete containing fly ash. Concrete specimens were moist cured for 7 and 100 days...
Relationship Between Laboratory Aging Tests and Field Performance of Asphalt-Concrete Mixtures
Aging of asphalt mixtures is primarily associated with loss of volatile components and oxidation in asphalt during the construction phase (short-term aging), and progressive oxidation...
Return to search