Effect of Joint Rigidity on Buckling Strength of Single Layer Lattice Domes
The present paper discusses the effect of the joint rigidity on the buckling strength of single layer lattice domes, with regular three way grids, under vertical loading. The effect of...
Membrane Structures: Technological Innovation and Architectural Opportunity
Presented is a list of materials used in building an airhouse. There are so many other moves in tensile structures and the present interest is in ETFE foils because of light transmission/cost...
Helium-Supported Hangar for a Small Solar-Powered Airship
For the IGA Expo '93 the Institute for Statics and Dynamics of Aerospace Structures, University of Stuttgart, together with Stuttgart Solar e.V. developed a solar-powered airship. For...
Current State of Development and Future Trends in Employment of Air-Supported Roofs in Long-Span Applications
Considered here is the low-profile, long span air-supported roof, as opposed to the high-profile 'bubble' variety, which has seen a substantially different development and expectation....
Spatial Structures Erected out of Thin Shell Elements Fabricated on Plane Followed by Bending
The paper offers the examples of spatial structures of average spans (up to 24 m) and engineering structures made of prefabricated curvilinear elements originally having a plane form....
Ultimate Strength of R/C Cooling Tower Shell
Reinforced concrete(R/C) cooling towers are the largest, thin shell structures. It is important to assess the ultimate strength of R/C cooling tower shells subjected to wind load. In the...
Punching Shear of Reinforced Concrete Shell Structures
In reinforced concrete shells punching shear failure may take place, if heavy concentrated loads are applied. Such failure is undesirable, since it does not provide adequate warning and...
How to Optimize Light-Gage, Cold-Formed Steel Beams
The Illustrative Examples section of the AISI Cold-Formed Steel Design Manual (AISI 1989) demonstrates how to analyze a number of different cold-formed steel sections. This paper applies...
Structural Analysis for Structural Design
This paper presents a simple extension to conventional structural analysis that serves to provide additional information that is of significant use to the structural design process. Specifically,...
Concrete Watertight Structures and Hazardous Liquid Containment
The purpose of
Replacement of a Failed Embankment Designed to Accommodate Large Settlement: A Case Study
Thick deposits of soft, normally to slightly preconsolidated, organic clay are common at low elevations along the riverbanks of southeast Texas. Both the moisture content and liquid limit...
Settlement Analysis of Landfill Liners over Deep Mined Areas
Tensile strains due to differential settlement from past mining activities were evaluated for a landfill liner. The landfill cell encompasses 20 acres and is located on a subsurface profile...
Settlement Predictions at a Florida Port Facility
A paved container storage area approximately four acres in size has been constructed at the existing Port of Fernandina in Fernandina Beach, Florida. Approximately one-half of the site...
Nonlinear Undrained Lateral Response of Rigid Drilled Shafts Using Continuum Theory
The nonlinear undrained response of rigid drilled shafts under static lateral and moment loading is evaluated within the context of elastic continuum theory. The approximate approach utilizes...
The Role of Shale Pores in Settlement
Waste fills resulting from the mining of coal in Appalachia should ideally consist of large, free-draining sedimentary rock fragments. The successful performance of these embankments is...
A Study of Alkalinity Leaching and Residual Strength of Alkaline Stabilized Sludge
The addition of sufficient amounts of quicklime or other alkaline earth oxides to dewatered sludge raises both the pH and temperature of the sludge, resulting in microbial inactivation....
Practical Method for Scour Prediction at Bridge Piers
A practical method is presented for prediction of local scour at bridge piers which is based on a comparison of many well known equations and supported by field data. This equation includes...
Comparison of Headcut Advance Testing and Soil Test Results
This paper presents the results of a study conducted in a flume to determine headcut advance rates of two base soils compacted at various compaction moistures and placement energies. The...
Width Adjustment: Relative Dominance in Unstable Alluvial Streams
The mechanisms that control the relative dominance of width adjustment in unstable streams are described. Specifically, the role of the following factors affecting the fluvial environment...
Stiffness of Low Rise Reinforced Concrete Shear Walls
This report,
Return to search