Bank Stability Analyses Versus Field Observations
The concept and process of stream bank stabilization design through the development and use of limiting stability curves for the comparison of existing bank height/angle combinations to...
Economics of Floods, Scour, and Bridge Failures
Hydraulic events occur more often and account for more losses than any other natural disaster. The damage inflicted on our nation's highway facilities during these events not only results...
The Control and Monitoring of Local Scour at Bridge Piers
A series of flume experiments revealed a possible method of reducing local river bed scour at bridge piers, thereby, reducing the risk of bridge failure. Three prototype schemes were installed...
Pressure Relief Under Hydraulic Jump Stilling Basins
Gravity drainage cannot be used for any portion of a structure located below tailwater level. Yet, drainage of this area may be required to relieve sub-floor pressures and reduce the risk...
Storm Drainage Channel Rehabilitation
30 km (19 miles) of existing concrete lines storm drainage channels were studied due to repeated failures. Alternate failures causes were hypothesized and evaluated. Physical testing was...
Threats to Bridge Stability from Scour Related Failures of Drop Structures
Catastrophic failure of bridge foundations may occur when channel bed elevations are lowered unexpectedly. Bridges to be constructed in channels that are known to have bed degradation...
Model Study of Center Hill Fuse Plug Spillway
Model tests of a fuseplug spillway mounted on the fixed crest of an embankment dam were conducted to develop a satisfactory design that would fail in a orderly fashion at a prescribed...
Progressive Failure of an Overtopped Embankment
The failure of an overtopped embankment is a problem of a very complicated nature. Concerned organizations are interested in information that can be used in future planning and development...
Local Scour at Bridge Piers in Alberta?Case History
A two span steel truss bridge with a rectangular concrete central pier was built over the Oldman River near Brocket in south-west Alberta in 1954. Initially the bridge was built square...
Probability of Bridge Failure Due to Scouring
Models to estimate depth of scour at bridge piers and abutments are available in many forms,but all of them are based on constant discharges. Their results vary widely and engineering...
Design of Composite Slabs for Vertical Shear
Three major modes of failure should be considered in the design of the positive moment regions of composite slabs incorporating profiled steel sheeting, viz.: flexure, longitudinal slip...
Proposal on Story Drift Limit Based on Axial Behavior of Column under Seismic Loads
The main function of columns primarily is to support axial loads both under and after repeated lateral loading from earthquakes. A definition of the story drift limit in any structural...
Behavior of Concrete-Filled Steel Tubular Three-Dimensional Subassemblages
Three-dimensional subassemblages consisting of a concrete-filled steel tubular column and four H-shaped beams were tested under a constant axial load on the column, constant beam loads...
The Behaviour of Reinforced Concrete Beams Manufactured with Side Profile Sheets
The paper describes in qualitative terms the fundamental principles that control the behaviour of a completely new form of construction in which reinforced concrete beams are constructed...
Validation of SHRP Performance Graded Binder Specifications Using Field Simulation Testing Equipment
The Strategic Highway Research Program (SHRP) was initiated to improve the effectiveness of laboratory test methods in predicting field performance. European highway agencies are using...
Computer-Aided Liability
Civil engineers are using computers more than ever to help them streamline analysis and design, boost productivity and cut costs. Often they rely on mass-marketed software such as Autodesk...
Reliability-Based Analysis and Design of Flexible Airfield Pavements
This paper illustrates, a new reliability-based procedure to analyze existing pavements and design new pavements that is being developed by the U.S. Air Force. The procedure uses a rigorous...
Pavement Design Considerations for Heavy Aircraft Loading at BAA Airports
BAA operates seven airports in the United Kingdom. Two of them, Heathrow and Gatwick, handled 61 million passengers in 1991 with 543,000 air transport movements, 25% by wide-bodied aircraft....
Ft. Campbell Airfield Emergency Reconstruction
The air deployment from Fort Campbell, Kentucky to Saudi Arabia in support of Operation Desert Storm in the summer and fall of 1990 involved several hundred C5 and C141 aircraft loaded...
Fracture Mechanics
This brief report, prepared by ACl 447 Subcommittee 2, reviews recent advances in finite element modeling of fracture and damage in concrete structures. The fundamentals of the fracture...
Return to search