Engineering Hydrology
This proceedings,
Hydraulic Engineering
This proceedings,
Permeability Determination for Unsaturated Soils
A reliable approach for the determination of the soil hydraulic conductivity function relies on the parameter estimation solution approach in which heterogeneous state of saturation within...
Transit Times Through Compacted Clay Liners
Transit time, or time taken by waste liquid to move through the thickness of the liner, is a short-term performance parameter which can be used to determine the necessary liner thickness....
A Design Manual for Coastal Fluidization Systems
This paper summarizes a recently completed design manual on fluidization systems to manage sand in the coastal environment for sand bypassing at inlets and harbor mouths and for creating...
Should the U.S. Accept the Concept of Navigable Depth?
Navigable depth is defined as the maximum depth of water from the chart datum that is safe to accept as the bed of the channel, such that damage does not occur to a ship's hull and maneuverability...
Dynamic Compaction of Nuclear Waste
When ponding, caused by settlement of the original soil cover over low-level nuclear waste buried at the Department of Energy's Savannah River Nuclear Plant near Aiken, S.C.,...
Cleaning Up Chromium
From 1956 to 1985, the United Chrome Products plant in Corvallis, Oregon, took a steady toll on the environment. Leaky plating tanks and the discharge of rinse water into a disposal pit...
Wave Interaction with Fluid Mud in Rectangular Trench
Wave interaction with fluid mud in a rectangular trench is studied theoretically based on small-amplitude wave theory. The problem was formulated using the Voigt model for an viscoelastic...
Aspects of Parallel Processing in Reservoir Simulation
Vectorization techniques have proved to be extremely effective for large-scale reservoir simulations. Parallel capabilities hold even greater potential for these enormous problems. Domain...
Nonlinear Behavior of Thin Slender Free Surface Non-Newtonian Elliptical Rings
This paper analyzes the nonlinear motion of a slender concentric thin elliptical ring of an incompressible, non-Newtonian fluid. This study includes the physical effects of surface tension,...
Computerized Tomographic Analysis of Fluid Flow in Fractured Tuff
The purpose of this summary is to demonstrate the usefulness of X-ray computerized tomography to observe fluid flow down a fracture and rock matrix inhibition in a sample of Bandelier...
Water Wave Generated by a Porous Wavemaker
A vertical porous wavemaker sitting in an infinitely long channel of constant depth is studied. The wavemaker performs horizontal oscillatory motion. A simplified analytical approach for...
Dynamic Response of an Infinite Beam Supported by a Fluid
The objective of this study is to investigate the dynamic response of an infinite beam supported by a fluid on one side, and subjected to dynamic loading on the other side. The fluid underneath...
Computation of Wind Pressures on L-Shaped Buildings
The paper refers to the numerical simulation of turbulent wind conditions around an arbitrarily-shaped building composed of two rectangular blocks. The time-averaged Navier-Stokes equations...
Wind Effect on Oblique Motion of Two Bodies in a Uniform Flow
The wind effect on the general translational motion of a circular cylinder through an inviscid and incompressible fluid, conveyed by a uniform flow at infinity, in the vicinity of another...
Three-Dimensional Thermal Jump in Stratified Cooling Channel
This study is concerned with basic properties of three-dimensional thermal jumps. Temperature measurements obtained in three-dimensional thermal jumps are presented. The jumps analyzed...
Computation of Flow in Ice-Covered Dune-Bed Channels
A numerical method for solution of the Reynolds-averaged Navier-Stokes equations is developed to study the flow over sand dunes in two-dimensional channels. The method is applied to calculate...
Turbulence, and Energy Loss, at Combining Pipe Junctions
Efforts to measure and describe the loss of energy at 90? sharp-edged junctions are described. The work is focussed on energy losses at discharge and area ratios for which there are no...
Flow Visualization of Lid-Driven Cylindrical Cavity Flow
The lid-driven cylindrical cavity flows in the laminar region are quantitatively visualized by a new flow visualization method called the digital vector velocimetry method. Particle streak...
Return to search