CORMIX1: Expert System for Mixing Zone Analysis of Pollutant Discharges Into the Water Environment
The Cornell Mixing Zone Expert System (CORMIX) is an integrated software package for the analysis, prediction, and design of aqueous toxic or conventional pollutant discharges into watercourses....
Groins and Vanes Developed Basing Upon a New Concept of Bank Protection
At curved bends, scour at the outer bank always accompanies deposition at the inner bank. A highly efficient river course for flood flow is considered to have a small lateral gradient...
Beach Erosion Protection Methods: Case Study of Dar City Tanzania
Coastal Tanzania has been experiencing severe beach erosion. Beach erosion is much felt in coastal cities like Dar es Salaam, Tanga etc. Beach erosion in Dar es Salaam has caused damage...
State-of-the-Art Report: Mexico
Design recommendations for groins and spur dikes are presented. For groins the most important ones are: to build them with sloping crests, orientated downstream and maximum spacing of...
Relief of an Urban Storm Drainage System
The Peaks Branch storm sewer system was designed in the 1930s to drain 5.7 square miles of East Dallas. Subsequently, development blocked the emergency overflow paths and many areas are...
Convergence Experiments with a Hydrodynamic Model of Port Royal Sound, South Carolina
A two-demensional, depth-averaged, finite-difference, flow/transport model, SIM2D, is being used to simulate tidal circulation and transport in the Port Royal Sound, South Carolina, estuarine...
The Use of Distributed Rainfall-Runoff Models Based on GIS at Different Scales of Information
The effects of spatial variability of soil type and land use on basin response are investigated. This is modelled thorugh a distributed approach specifically designed for calibration from...
SWMM Application in Indian River County, Florida
The EPA's Storm Water Management Model (SWMM) was used to simulate drainage canal system network within Indian River County, Florida. Runoff and Extran module of the PCSWMM...
Experience with Cavitation in High Pressure Slide Gates
The Bureau of Reclamation has many years of experience in the design and operation of high pressure slide gates. This paper discusses the historical use of high pressure slide gates by...
Design, Construction and Testing of Repairs to the Low Level Outlets at Terzaghi Dam
Operation of the low level outlets (LLOs) at Terzaghi Dam in southwestern British Columbia resulted in severe cavitation at operating heads significantly lower than design. Modifications...
Handling of Intake Bulkhead at King Talal Dam
During raising of King Talal Dam in Jordan in 1986, the existing intake wheel gate provided at the inlet of the project Low Level Outlet Works (LLOW) tunnel was found inadequate to withstand...
Hydraulic Model and Prototype Experience on Old River Overbank Structure
Physical hydraulic model tests of the Old River overbank structure were conducted to investigate the hydraulic performance of the stilling basin and evaluate riprap stability and scour...
Extreme Flood Probability Estimates in Practice
Selecting the safety design flood for a dam or siting structures where flooding would cause severe social or economic disruption requires balancing the likelihood and consequences of failure...
Climate Change and U.S. Water Resources: Results from a Study by the American Association for Advancement of Science
The time horizon of the changes that might occur is similar to the time required for planning, approval, funding, construction and economic life of such major water facilities as dams,...
An Overview of Coastal Stormwater Drainage Problems
Considerable studies have focused on the drainage design in upland areas. In the Atlantic and Gulf Coastal region, the stormwater drainage presents many unique problems mainly due to the...
Special Hydraulic Problems Related to Coastal Louisiana Drainage Systems
The urbanized coastal areas of southeast Louisiana present unique problems for hydraulic engineers. These problems relate to the design of drainage systems serving leveed areas with flat...
Technical Considerations in Numerical Modeling of Pressure Reducing Valves in Water Distribution Systems
In large water distribution networks, pressure reducing valves (PRVs) are common water appurtenances. However, there are difficulties in representing them when using the Hazen-Williams...
Water Distribution System Design Considering Component Failure During Static Conditions
A continuous hydraulic availability relationship is presented which more realistically models minimum pressure requirements for water distribution systems. This relationship is used in...
Redundancy and Reliability of Water Distribution Networks: An Entropy Based Approach
Based on the concepts of entropy and graph theory, a functional form is developed as a quantitative measure for redundancy in water distribution networks. This function was obtained by...
Optimal Reliability Based Design for Water Distribution Systems
The methodology presented in this paper explicitly includes availability measures that incorporate both mechanical and hydraulic unavailability of system components for a dynamic system....
Return to search