Predicting Human Instability in Flood Flows
The delineation of high flood hazard zones within a flood plain is usually independent of the parameters that constitute a life threatening situation. In order to define human instability...
Application of Hydraulic and Sediment Transport Principles in the Design of Tidal Exchange Structures
This paper presents a procedure for the analysis and design of tidal exchange structures, such as tidal gates and training dikes. In lieu of over generalized theories or complicated modeling...
Geotechnical Aspects of River Bank Erosion
The principal geotechnical mechanisms of river bank failure are identified on the basis of extensive field investigations on many different river systems. The role of each factor depends...
Groins and Vanes Developed Basing Upon a New Concept of Bank Protection
At curved bends, scour at the outer bank always accompanies deposition at the inner bank. A highly efficient river course for flood flow is considered to have a small lateral gradient...
Beach Erosion Protection Methods: Case Study of Dar City Tanzania
Coastal Tanzania has been experiencing severe beach erosion. Beach erosion is much felt in coastal cities like Dar es Salaam, Tanga etc. Beach erosion in Dar es Salaam has caused damage...
State-of-the-Art Report: Mexico
Design recommendations for groins and spur dikes are presented. For groins the most important ones are: to build them with sloping crests, orientated downstream and maximum spacing of...
Control of Bank Erosion in The Netherlands. State-of-the-art
In the Netherlands the protection against flooding and the effects of inland navigation have always been extremely important. Many problems related to these items, among them erosion and...
Relief of an Urban Storm Drainage System
The Peaks Branch storm sewer system was designed in the 1930s to drain 5.7 square miles of East Dallas. Subsequently, development blocked the emergency overflow paths and many areas are...
SWMM Application in Indian River County, Florida
The EPA's Storm Water Management Model (SWMM) was used to simulate drainage canal system network within Indian River County, Florida. Runoff and Extran module of the PCSWMM...
Experience with Cavitation in High Pressure Slide Gates
The Bureau of Reclamation has many years of experience in the design and operation of high pressure slide gates. This paper discusses the historical use of high pressure slide gates by...
Design, Construction and Testing of Repairs to the Low Level Outlets at Terzaghi Dam
Operation of the low level outlets (LLOs) at Terzaghi Dam in southwestern British Columbia resulted in severe cavitation at operating heads significantly lower than design. Modifications...
Handling of Intake Bulkhead at King Talal Dam
During raising of King Talal Dam in Jordan in 1986, the existing intake wheel gate provided at the inlet of the project Low Level Outlet Works (LLOW) tunnel was found inadequate to withstand...
Hydraulic Model and Prototype Experience on Old River Overbank Structure
Physical hydraulic model tests of the Old River overbank structure were conducted to investigate the hydraulic performance of the stilling basin and evaluate riprap stability and scour...
Extreme Flood Probability Estimates in Practice
Selecting the safety design flood for a dam or siting structures where flooding would cause severe social or economic disruption requires balancing the likelihood and consequences of failure...
GEOPACK: A Geostatistical Software System
A comprehensive, user-friendly geostatistical software system called GEOPACK has been developed. The purpose of this software is to make available the programs necessary to undertake a...
An Overview of Coastal Stormwater Drainage Problems
Considerable studies have focused on the drainage design in upland areas. In the Atlantic and Gulf Coastal region, the stormwater drainage presents many unique problems mainly due to the...
Physical Modeling of Heated Discharges into a Stagnant River
An alternative cooling system study was performed for the Damietta Combined Cycle Plant in Egypt. The alternatives included spray canals, helper cooling tower and once-through cooling....
Overfall Stress and Pressure Distributions
The magnitude and distribution of hydraulic shear stress and pressure on the boundary of a straight drop overfall are presented for multiple overfall heights and flow rates. Hydraulic...
Energy Dissipation Structure for Fixed-Cone Valves
Results of a model study to investigate the hydraulic performance of a proposed energy dissipation structure for fixed-cone valves are presented. Procedures for estimating pressures and...
Southwest Pass Training Structure Alternatives
The U.S. Army Engineer Waterways Experiment Station system of computer programs, TABS-2, was utilized to evaluate various structural plans for increasing channel velocities and sediment...
Return to search