Pressuremeter Tests and Shoring Wall Design
Pressuremeter testing was used as an integral part in the design of the temporary tieback shoring wall for the Columbia Center office building in Seattle, Washington. Pressuremeter testing...
Correlation of Soil Parameters From In Situ and Laboratory Tests for Building 333
Pressuremeter, plate bearing and cone penetration tests were performed on the prepared foundation soil for Building 333 located in the Red River Army Depot near Texarkana, TX. The results...
Strength of Fine-Grained Soils Using the Piezocone
Evaluation has been made of several theories and methods for deducing the undrained and effective stress strength of saturated fine-grained soil from piezocone test results. Bearing capacity...
Pore Pressure Effects in Borehole Shear Testing
The effects of excess pore pressures on shear strength results obtained using the Borehole Shear Test (BST) were investigated. Pore pressures were measured during the consolidation, shear,...
Determining Sand Strength by Cone Penetrometer
Evaluation has been made of several theories and methods for deducing sand strength from cone resistance. Bearing capacity theories, cavity expansion theory, and empirical methods have...
In Situ Testing of Calcareous Sand?Campos Basin
Sampling and in situ testing were used to investigate soil conditions for the installation of offshore platforms at the Campos Basin, Brazil. At these sites calcareous sand formations...
The Mudslide Profile Method to Measure the Undrained Shear Strength of Muds
Mudslides have been reported to have a very distinctive profile. Using this distinctive profile, a method is presented to analyze the stability of the mudslide at limit equilibrium conditions....
Vane Shear Testing for Staged Construction
Staged construction was used for the earthfill embankment of Birch Dam in order to compensate for low strength clays in the foundation. Sampling and testing of foundation soils verified...
Interpretation of CPT Data for Design of Earth Dams Near Tehachapi, California
The Static Cone Penetration Test (CPT) was used to obtain needed geotechnical information for design and construction of two small earth dams near Tehachapi, California. The basic CPT...
Fast, Economical, Cone Testing of River Sediments
The objective of the study reported was to obtain quantitative geotechnical information over many square miles of Hudson River bottom. A hand held cone penetrometer was selected for use....
Taming Lively Buildings
Mechanical damping systems are increasingly being used for controlling dynamic responses of tall buildings. Several types of dampers are described, and compared, beginning with the three...
New Approaches to Rehabbing Old Dams
The U.S. Bureau of Reclamation takes a look at several new ways of building old dams for maximum flooding. A labyrinth spillway was built at Ute Dam near Logan, N.M. to increase reservoir...
Postmodern Engineering
Momentum Place is a postmodern skyscraper in Dallas designed by architects John Burgee and Philip Johnson. The Datum-Moore Partnership, structural engineers, designed the structural system...
Audits & Analyses?New Jersey's Approach
The New Jersey Department of Environmental Protection is responsible for implementing environmental policy and administering a regulatory structure based on reliable research and monitoring....
Sea Level Rise and Coastal Stormwater Drainage
Global sea level rise as a result of the greenhouse effect and the past trend and future projection on the rise are discussed. Potential problems associated with coastal stormwater drainage...
Incorporating Judgment into an Optimization Model of a Wastewater Treatment System
The use of design variable constraints according to textbook and state design standards might cause potentially good designs to be missed and would not capture the fuzzy interaction of...
Relative Landslide Susceptibility in Davis County, Utah?A Multivariate Approach
The complex distribution of soil properties makes prediction of slope stability extremely difficult in these mountain watersheds. The need to assess these watersheds for their susceptibility...
Investigating and Treating Chromium in Ground Water at a Wood Treater in California
A wood treating facility, operating for more than five years without required permits, contaminated soil and ground water on and offsite. The company moved slowly in response to enforcement...
Plunge Pool Energy Dissipators for Some Dams in Taiwan, ROC
This paper presents a brief description of the characteristics of the plunge pool type energy dissipators, including design considerations, hydraulic model tests, as well as the results...
Modeling of the Undular Jump for White Water Bypass
Two of the authors have reported previously on the hazard that a conventional hydraulic jump with a uniform reverse surface roller presents to white water boaters. The intent is to create...
Return to search