A Case History of Leakage from a Surface Impoundment
A manufacturing company constructed a 48-acre (19 hectare), unlined surface impoundment at a site in northern Texas to store wastewater. The site is underlain by unsaturated, alluvial...

Water Balance Approach to Prediction of Seepage from Mine Tailings Impoundments, Part I: General Water Balance Approach
The prediction of seepage from a tailings impoundment requires careful evaluation because the predictions can have significant economic impact upon designs, as well as permit stipulations...

Seepage Control for Embankment Dams USBR Practice
The current Bureau of Reclamation approach to seepage assessment, analysis, and design for embankment dams is described. The advantages and appropriate applications for the analysis programs...

Grout Penetrability
The ability of a grout to penetrate a formation is always a selection requirement for projects in which fracturing is undesirable. The major grout properties affecting penetrability are...

Some Aspects of Analysis and Prediction of Subsidence
A procedure based on the nonlinear finite element analysis was investigated for the prediction of subsidence caused by longwall mining. This paper presents a case study involving predictions...

Application of Displacement of Discontinuity Methods in Underground Mine Design
Displacement discontinuity methods for stress analysis, pioneered by Starfield and Crouch (see, for example, Starfield and Crouch, 1972; Crouch, 1976; and Crouch and Starfield, 1983),...

An Application of Probability to Rock Slope Design
This paper describes the use of probability and statistics in the slope design process. An example is presented of a high rock slope in an open pit mine. This slope is a major concern...

A Combined Limit Equilibrium and Statistical Analysis of Wedges for Design of High Rock Slopes
This paper describes a unique technique developed for the statistical analysis of wedge failures which control the design of high slopes in relatively hard jointed rock masses. Using this...

Probability Applied to Slope Design?Case Histories
A major problem encountered with the choice of an appropriate value for the design probability. Initial experience, obtained during open-pit investigation, suggested that slope geometry...

Fracture Mechanics Analysis of Massive Hydraulic Fracturing Containment
The hydraulic fracturing containment problem is the subject of the present investigation. Unlike previous studies, the interface crack geometry with the correct crack tip singularity was...

On the Design of Continuous Composite Beams
Methods of analysis and design of continuous composite beams are presented. Numerical analysis is used to determine the effective width of the slabs to be used in design. The influence...

Proposed Design Criteria for Composite Steel Deck Slabs
Composite steel deck slabs have continued to gain popularity; today they are one of the predominant means of floor slab construction in most typical buildings. The term 'composite...

Dynamic-Fatigue Response of Continuous Composite Bridges
The dynamic response of continuous composite bridges and the influence of fatigue loading at resonance frequency on the structural response are investigated. It is shown that cracking...

Strength of Biaxially Loaded SRC Columns
The paper presents the results of an experimental study on the elasto-plastic behavior of 'Steel reinforced concrete (SRC)' columns subjected to biaxially eccentric...

Composite and Mixed Construction in Czechoslovakia
Various composite and mixed systems have been used in Czechoslovakia. Special attention is focused on design methods, effective construction, and material savings. Current developments...

Critical Load Program
The elastic critical load of a structural frame is a fundamental parameter in assessing its stability. It is an upper bound to the failure load of the frame, in the same way that the Euler...

Computers in a Planning Context: Another Reality
Over the past twenty years water resources planning has seen a great increase in the development of computer methods of analysis. This has transformed the way the hydrology, hydraulics,...

Micro Use in Water Management in the Brazos Basin
The Brazos River Authority, an agency of the State of Texas created to conserve and develop the surface waters of the 42,000 square mile (110,000 km) Brazos River Basin, is in the midst...

A Micro-Computer GIS for Water Resources Planning
Recent developments in micro-computers have enabled water resources engineers to utilize advanced computer methods and interactive color graphics for the analysis and planning of water...

Water Resources Applications of OCAP--Ohio's CNRIS
The Ohio Capability Analysis Program (OCAP) is a computer-based natural resources information system (CNRIS) operated since 1973 by the Ohio Department of Natural Resources. The three...

 

 

 

 

Return to search