An Application of Probability to Rock Slope Design
This paper describes the use of probability and statistics in the slope design process. An example is presented of a high rock slope in an open pit mine. This slope is a major concern...
A Combined Limit Equilibrium and Statistical Analysis of Wedges for Design of High Rock Slopes
This paper describes a unique technique developed for the statistical analysis of wedge failures which control the design of high slopes in relatively hard jointed rock masses. Using this...
Probability Applied to Slope Design?Case Histories
A major problem encountered with the choice of an appropriate value for the design probability. Initial experience, obtained during open-pit investigation, suggested that slope geometry...
Fracture Mechanics Analysis of Massive Hydraulic Fracturing Containment
The hydraulic fracturing containment problem is the subject of the present investigation. Unlike previous studies, the interface crack geometry with the correct crack tip singularity was...
Modelling of the Fracture Process Zone in Rock
There are a number of situations in the fracture mechanics of rock in which linear elastic fracture mechanics (LEFM) concepts are inapplicable or insufficient. Two such situations are...
Simulation of Rock Fracture with the 3-D SHALE Code
The 3-D SHALE code simulates the propagation of stress waves and the occurrence of fracture in brittle solids. The physical models and numerical methods in this code are similar to those...
Can Clay Liners Work?
Nearly all liners for landfills and surface impoundments were constructed from compacted clay until about five years ago. But this is no longer so. In the past few years, clay liners used...
On the Design of Continuous Composite Beams
Methods of analysis and design of continuous composite beams are presented. Numerical analysis is used to determine the effective width of the slabs to be used in design. The influence...
Proposed Design Criteria for Composite Steel Deck Slabs
Composite steel deck slabs have continued to gain popularity; today they are one of the predominant means of floor slab construction in most typical buildings. The term 'composite...
Strength of Biaxially Loaded SRC Columns
The paper presents the results of an experimental study on the elasto-plastic behavior of 'Steel reinforced concrete (SRC)' columns subjected to biaxially eccentric...
Bond Stress of Embedded Steel Shapes in Concrete
This paper describes an investigation into the bond stress developed between steel shapes and reinforced concrete when the concrete is lightly stressed. A brief discussion of previous...
Shear Strengths of Concrete-Filled Steel Box Elements
This study evaluated the ultimate strengths as well as the effect of the ultimate composite actions of concrete-filled steel composites under combined bending, shear, and axial forces....
Composite Columns?Design and Examples for Construction
The new German standard DIN 18806, part 1 gives the rules for the design of composite columns. The general method, taking into account all the inhomogeneties of the two materials steel...
Composite and Mixed Construction in Czechoslovakia
Various composite and mixed systems have been used in Czechoslovakia. Special attention is focused on design methods, effective construction, and material savings. Current developments...
Critical Load Program
The elastic critical load of a structural frame is a fundamental parameter in assessing its stability. It is an upper bound to the failure load of the frame, in the same way that the Euler...
Computers in a Planning Context: Another Reality
Over the past twenty years water resources planning has seen a great increase in the development of computer methods of analysis. This has transformed the way the hydrology, hydraulics,...
Micro Use in Water Management in the Brazos Basin
The Brazos River Authority, an agency of the State of Texas created to conserve and develop the surface waters of the 42,000 square mile (110,000 km) Brazos River Basin, is in the midst...
A Micro-Computer GIS for Water Resources Planning
Recent developments in micro-computers have enabled water resources engineers to utilize advanced computer methods and interactive color graphics for the analysis and planning of water...
Water Resources Applications of OCAP--Ohio's CNRIS
The Ohio Capability Analysis Program (OCAP) is a computer-based natural resources information system (CNRIS) operated since 1973 by the Ohio Department of Natural Resources. The three...
Storage Projection for Reservoir Systems
Two methods are studied for determining the probability distribution of future levels of storage in a reservoir system: transient analysis and Gould's probability matrix method....
Return to search