An Expert System for Inactive Hazardous Waste Site Characterization
The area of hazardous waste management is a broad and multidisciplinary field requiring expertise in engineering, geology, chemistry and toxicology, and is an ideal area for the application...
Design and Planned Use of a 2-Kiloton Eccentric Mass Vibrator
High-level testing of large civil structures is usually not practical, due to structural damage considerations and available testing equipment. However, in the case of a joint American/German...
Frequency Domain Analysis of a Tank-Soil System
The dynamic response of an elastic cylindrical tank supported on a rigid base under a harmonic vertical excitation is analyzed taking into consideration its interaction with the foundation...
Cleaning Up Toxics
Case histories show how several different types of contamination cleanup were handled. In Attleboro, Mass., washwater, used to decontaminate equipment and tools after cyanide was removed...
Attapulgite: A Clay Liner Solution?
Poor performance of clay liners at waste management facilities has resulted in the EPA mandate of synthetic polymeric liner materials to comply with zero penetration requirements. Laboratory...
U.S.-Japan Coordinated Program on Masonry Research
An overview of the U. S. -Japan Coordinated Program on Masonry Research is presented. The program consists of parallel efforts in Japan and the United States to develop design methods...
Sequential Earthquake Response of an Earth Dam
Sequential earthquake-response records of the well-instrumented Long Valley earth dam (Mammoth Lake area in California) are analyzed and engineering interpretations are made. The dam,...
Importance of Phasing of Strong Ground Motion in the Estimation of Structural Response
In this paper, the influence on Fourier phase spectrum of seismic source directivity due to rupture propagation along the earthquake source is investigated. The phasing is described using...
Dynamics of Fender and Rack Systems for Docking Ferries
A dynamic analysis of a ferry fender and rack system is developed based on the conservation of energy principle and Newton's laws of motion. The dynamics of the interaction...
Dynamic Testing of Structures Using the RESCUE Technique
This paper describes the most recent phase of an NSF supported program at SRI International to develop the technique of repeatable earth shaking by controlled underground expansion (RESCUE)...
Pseudo-Dynamic Testing of Structural Components
The pseudo-dynamic testing procedure is a simultaneous simulation and control process in which inertia and damping properties are simulated and flexibility properties are acquired from...
Seismic Tests of Friction Damped Steel Frames
This paper presents the results obtained from qualification tests of a new friction damping system, which has been proposed in order to improve the response of Moment Resisting Frames...
Hysteretic Behavior of Composite Diaphragms
Floor systems constructed with steel-deck-reinforced concrete are described. When used to resist lateral loads these systems are referred to as diaphragms. A description of a test arrangement,...
Precast Roofs for Blast Shelters
A shallow-buried reinforced concrete blast shelter has been constructed and dynamically tested at the U. S. Army Engineer Waterways Experiment Station (WES). Three thicknesses of precast...
Field Tests of Wind-Structure Interaction
The present study was initiated to investigate the possible causes for excessive lamp failure rates on High Mast illumination towers in the State of Minnesota. The study consisted of two...
Vibration Tests of Reservoir Structures Outlet Tower and Footbridge
This paper presents a field test procedure used in determining the dynamic properties of an outlet tower and footbridge for a major reservoir. Such factors as virtual water mass, soil-structure...
Dynamic Tests of LNG Storage Tanks for Earthquake Analysis of Liquid-Tank-Pile-Soil Interaction
This paper presents a field test procedure for determining the dynamic properties of large liquid natural gas (LNG) storage tanks under operating conditions. Two methods of vibratory excitation...
Refinements in Pseudo-Dynamic Test Procedures
One of the major concerns in seismic testing is whether the loading conditions imposed on a structure adequately represent those that might occur during a major earthquake. Response simulation...
Use of Vibration Tests to Determine Lateral Load Paths in Medium Rise Buildings
A structural system identification procedure is described in which an initial analytical model of a building is modified until it predicts accurately the mode shapes and natural frequencies...
Seismic Behavior of Long-Span Cable-Stayed Bridges
Special features of the earthquake-response analysis of cable-stayed bridges, subjected to multiple-support excitation, are presented including a basis for calculation of seismic forces...
Return to search