Criticality of Density Intrusions
Previous analyses of density intrusions indicates that a steady interface cannot be maintained if the front propagates at a speed greater than that of long interfacial waves. Supercritical...
Top Width of Pier Scour Holes in Free and Pressure Flow
The maximum top width of the local scour holes at piers is shown to be a simple function of the scour depth and the angle of repose of the bed material in water. Knowledge of the top width...
Preliminary Studies of Pressure Flow Scour
Bridges that become inundated during floods have slightly pressurized flow that impacts bridge piers and creates an aggravated scour condition. Results of two preliminary laboratory studies...
Mixing Characteristics of a Transitional Stratified Two-Layer Flow
Small scale structures in a stably stratified two-layer flow are investigated. The flow configuration has the initial velocity interface displaced with respect to the density interface....
A 2-D Numerical Model for High Velocity Channels
The hydraulic performance of a high velocity channel depends on maintaining a supercritical flow regime over specified portions of its length. Predicting the potential location of shocks...
Visualization and Analysis of Multi-Dimensional Velocity Measurements in Carquinez Strait, California
On 11 March, 12 March, 15 April, and 16 April, 1991 the United States Geological Survey (USGS), Sacramento, CA, employed a Downward Looking Acoustic Doppler Current Profiler (DL-ADCP)...
Selective Withdrawal in a Rotating Stratified Fluid
In this paper we consider the axisymmetric flow of a rotating stratified fluid into a point sink. Linear analysis of the initial value problem of flow of a linearly stratified fluid into...
Pressure Relief Under Hydraulic Jump Stilling Basins
Gravity drainage cannot be used for any portion of a structure located below tailwater level. Yet, drainage of this area may be required to relieve sub-floor pressures and reduce the risk...
Mass Transport in Mud Layer Induced by Wave Action
This paper analyzes the mass transport velocity in a two layers system produced by wave action. In a previous paper, Piedra Cueva (1933), a theory for linear water waves propagating in...
Scour at Highway Structures in Tidal Waters
Scour analysis of bridges over tidal waterways uses the same scour equations as for the rivers. However, determining the hydraulic variables to use in the equations is complex. A major...
Model Technology for Estimating Storm-Induced Currents
This paper demonstrates the application of the one-dimensional shallow-water equation model DYNLETI at Brunswick Harbor, Georgia to simulate storm-induced velocities precisely at a bridge...
Indian River Inlet: Is There a Solution?
Man-made changes at Indian River inlet, Delaware, have occurred over the past 6 decades. During this period the tidal prism of the Indian River-Rehoboth Bays system has increased along...
Bridge Hydraulic Design in Tidal Situations
The analysis of bridge hydraulics and scour potential in tidal waters, in comparison with inland rivers, requires consideration of various additional factors. This paper condenses a simplistic...
McCormick Bridge Scour Evaluation?A Case Study of a Tidal Bridge
Although the Federal Highway Authority has implemented procedures for bridge scour analysis in their HEC-18 publication, they do not indicate a procedure for scour depth determination...
Halloween Wave Transformation Near Virginia Coast
The Halloween Northeaster of October 29-31, 1991 generated a unique severe sea. The storm waves propagated through two wave stations which are 87 km apart. The wave spectra of the storm...
Repeatability and Oblique Flow Response Characteristics of Current Meters
Laboratory investigation into the precision and accuracy of various mechanical-current meters are presented. Horizontal-axis and vertical-axis meters that are used for the measurement...
Friction Loss Equations for Hydropower Facilities
Many water suppliers are pursuing economic benefits from water supply and distribution systems through development of hydropower facilities on pipelines. Excessive pressure head that used...
Hydraulic Modeling of High Unit Discharge Energy Dissipators
The incorporation of an efficient and economical energy dissipation device is critical with respect to the safe operation of a high unit discharge spillway. The development and design...
A Comparison Between Two Kinematic Wave Solutions for Movement of Debris Flows
We compare an asymptotic kinematic wave solution for movement of debris flows with a solution obtained by the method of characteristics. The differences between the two solutions in the...
Roll Waves in Mud Flow
Permanent roll waves on a shallow layer of fluid mud which is modeled as a power-law fluid is studied. Based on long-wave approximation, momentum integral method is applied to derive the...
Return to search