Large Stone Hot Mix Asphalt: State of the Art
Improved mix characteristics can be achieved by utilizing existing well-known technologies. Developments have included: more attention to voids in mineral aggregate criteria; adjusting...
Large Stone Mixes Make a Comeback
Large stone hot mix asphalt common at the turn of the century, is making a comeback in popularity in hot mix asphalt design. Large stone hot asphalt mixtures are being used as a way to...
Wood Variability Effects in Structural Assessment
Engineers evaluating the load carrying capacities of in-service wood structures commonly determine the strength and stiffness properties of structural wood members by various assessment...
Bond Performance of Reinforcing Bars Embedded in Fiber Reinforced Concrete and Subjected to Monotonic and Cyclic Loads
The primary variables investigated were fiber content and loading history. The reinforcing bar size was ASTM #5. Steel fibers with hooked ends were used with four fiber contents, namely;...
Protection of Wood Designs in Adverse Environments
Engineers and architects are becoming increasingly aware of the risks of poor wood design practices and the benefits of using wood properly. This paper addresses biological factors that...
Sawn Lumber in Bridge Construction
This paper covers many aspects of design and construction that affect the specifications of the sawn wood components of a highway bridge. The relationships between the grading rules for...
Glued Laminated Timber for Bridge Construction
Structural glued laminated timber (glulam) was first introduced into the U.S. as a construction material in 1934. With the development of fully waterproof adhesives in the 1940's,...
Rate Effects on Fracture of Concrete
An analytical and experimental investigation of mode I (tensile and mixed mode (combined tensile and shear) fracture of concrete subjected to impact loading was conducted. The rate of...
Creep of Polycrystalline Ice
This paper discusses the extension of creep models for polycrystalline ice to include the effects of a non-monotonic loading history. Attention is focussed on cyclic loading since it is...
Premature Failures of Outdoor Masonry Pavements
The authors have investigated and repaired a number of premature inservice failures of masonry paving systems in recent years. These systems have become common, built over underground...
Repair of an Improperly Detailed Masonry Facade: A Case History
The masonry facade of an 18-story condominium building was constructed with an inconsistent pattern of shelf angle supports, marginal lateral restraints and without any horizontal control...
Design of Fiberglass Reinforced Plastic Underground Storage Tanks
The purpose of this paper is to discuss the design and construction techniques of fiberglass composite underground storage tanks. The scope of this paper is limited to the straight shell...
Three Tools for Design Test Bed Analysis
Three analytical tools are outlined for use in design test bed work focusing on the design/production interface. The tools are substitution analysis, coupling analysis, and value chain...
Durability of Fly Ash Concrete in the Marine Environment
This paper presents the experimental investigation of durability of air-entrained fly ash concrete in the marine environment. The findings indicate that the deterioration rate of durability...
Effect of Fly Ash on the Microstructure and Durability of Concrete
The influence of fly ash on the microstructure and durability of concrete was investigated. It was found that the use of 50% fly ash in concrete reduced greatly its resistance to freezing-and-thawing...
Permeability Effects on the Sulfate Resistance of Concrete
A laboratory study was conducted to determine the effect of permeability on the sulfate resistance of concrete containing fly ash. Concrete specimens were moist cured for 7 and 100 days...
Time-Dependent Behavior of FRP Lintels
This paper describes an experimental investigation into the short-term and long-term behaviors of two types of T-shaped lintels made of fiber-glass reinforced plastic with polyester or...
Early-Time Strength and Elastic Modulus of Concrete With High Proportions of Fly Ash
Compressive strength and elastic modulus data are presented for four concrete mixtures with ratios (by volume) of Class C fly ash to total cementitious materials (portland cement plus...
Parameter Study of Stresses in Mass Concrete Using Two Fly Ash Mixtures
Finite-element modeling of the incremental construction procedure for mass concrete structures has been used to study the effects of three mechanical properties on thermal stresses. Material...
Experimental Mixes to Minimize Rutting
This report describes the materials and construction details involved in the design and placement of four experimental mixes on I-95 (Richmond-Petersburg Turnpike) in 1985 and follows...
Return to search