Velocity Measurements by the One-Orange Method
Application of the most sophisticated instrumentation - so called state-of-the-art equipment - is not always necessary nor even desirable for measurement of mean velocities in verticals,...

Experimental Design and Measurement Techniques for Investigation of Two-Phase Flow
Discussing the relevant hydraulical and inter-phasial processes of two-phase flow in open tanks the necessary requirements for set-up and operation of physical model studies are worked...

Sediment Measurement Instrumentation A Personal Perspective
The development of the suspended sediment samplers in the 1940s was a major contribution to the science of sedimentation and provided for the proper development of dams, reservoirs, and...

Low-Cost Bridge Scour Measurements
This paper reports on the use of a low-cost, highly portable sonar system. The ease of use of the instrument and the short time required to make measurements should make this system valuable...

Using the SedBed Monitor to Measure Bed Load
An acoustic distance measuring device (SedBed Monitor) was developed to accurately measure bed surface transects in a sediment and water recirculating flume. From these transects the rate...

An Investigation of Turbulence in Open Channel Flow via Three-component Laser Doppler Anemometry
A three-component laser Doppler anemometer is used to reexamine the distribution of single-point mean statistics in a nearly uniform fully-developed 2D turbulent open channel flow of water...

Hot-Film Response in Three-Dimensional Highly Turbulent Flows
A methodology is described for accurate turbulence measurements with hot film or hot wires even at turbulent intensities as high as 100%. The assumptions involved and the approximations...

Experimental Study on Turbulent Structures in Unsteady Open-channel Flows
Turbulence measurements in unsteady open-channel flows over smooth beds were conducted accurately by the simultaneous use of two-component LDA system and water-wave gauges. In the inner...

Response of Velocity and Turbulence to Abrupt Changes from Smooth to Rough Beds in Open-channel Flows
Response of velocity distribution and turbulence characteristics to abrupt changes of bed roughness have been investigated experimentally with two-component laser Doppler anemometer (LDA)....

High-speed Video Analysis of Sediment-Turbulence Interaction
Results from the analysis of high-speed video recordings of particle motion and simultaneous flow visualizations in the near wall region of a turbulent open channel flow are presented....

Estimation of Mean Velocity for Flow Under Ice Cover
Methods of estimating mean velocity in a vertical from point velocity measurements are compared for an ice-covered channel. The comparison is based on velocity profiles obtained from a...

Effects of Simulated Ice on the Performance of Price Type-AA Current Meter Rotors
Slush ice readily adheres to the standard metal rotor of the winter Price type-AA current meter and affects the ability of the meter to measure the flow velocity accurately. Tests conducted...

Innovative Instrumentation for a Physical Model of River Ice Transport
Large physical models often require the use of innovative instrumentation and measurement techniques. Hydraulic models that attempt to simulate the effects of stationary ice covers put...

Developing Air Concentration and Velocity Probes for Measuring Highly-Aerated, High-Velocity Flow
The U.S. Bureau of Reclamation's stepped spillway overtopping protection research program required velocity and air concentration profile data be obtained during testing in a large, 15.2-m-high...

Void Fraction Measurement Techniques for Gas-Liquid Bubbly Flows in Closed Conduits; A Literature Review
This paper provides a review of void fraction measuring techniques for gas-liquid bubbly flows in closed conduits with emphasis on the suitability of these methods for air-water bubbly...

Measuring Air Concentration in Flowing Air-Water Mixtures
This paper describes the use of an electrical conductivity probe to determine aeration of a plunge pool by an overfall nappe. The probe was calibrated using an apparatus designed to provide...

Application of a Needle Probe in Measuring Local Parameters in Air-Water Flow
In this paper, development of a double needle probe for measuring local parameters in air-water mixtures is explained. This probe is designed to measure flow velocities up to 10 m/s and...

Anomalous Measurements in a Compound Duct
An anomalous velocity distribution on the 'flood plain' of a compound duct is reported and discussed. The tentative conclusion is that the phenomenon is to be explained by the co-existence...

Measurements of the Hydrodynamic Lift and Drag Forces Acting on Riprap Side Slope
Direct measurements have been made of lift and drag forces acting on a 20.1 mm spherical particle placed within the riprapped 1.5 H: 1 V side slope of a 10 m long channel which was protected...

Recent Applications of Acoustic Doppler Current Profilers
A Broadband acoustic Doppler current profiler (BB-ADCP) is a new instrument being used by the U.S. Geological Survey (USGS) to measure stream discharge and velocities, and bathymetry....

 

 

 

 

Return to search