Suburban Superfund
Discovery of methane seeping into houses at a new development near Newark, Del. set off investigations that eventually led to the U.S. EPA declaring the site eligible for Superund cleanup...
The Challenge of Yucca Mountain
Yucca Mountain is the most likely site for the nation's high level nuclear wastes. Congress chose the site out of three candidates for further study before designating it...
Building a Better Landfill Liner
A soil liner project was sponsored by the EPA to provide information on the construction factors that affect the permeability of compacted soil liners. After construction of a field liner,...
The Effect of Stiffness Degradation on the Three-Dimensional Seismic Response of Highway Bridges
This paper describes the effect of modeling of the inelastic pier behavior on the seismic response of three reinforced concrete bridges. Each bridge was analyzed twice once using a yield...
Experimental Evaluation of Performance of Earthquake Restrainers in Box Girder Bridges
Type C-1 restrainers were used in most of the concrete T- and box girder bridges which have been retrofit. Type C-1 restrainers consist of 7-3/4 in. diam. galvanized cables, bearing plates,...
Vertical Response Data from the Dominion Road Bridge Test
In January and February of 1985, two bridges were tested in New Zealand using simulated earthquake loads. The objective was to determine the in-situ seismic response of two reinforced...
Rapid Visual Screening of Buildings for Potential Seismic Hazards
A Rapid Screening Procedure (RSP) developed for use nation-wide is based on a 'sidewalk survey' of a building, in which a Data Collection Form is completed by...
ATC 14: A Methodology for the Seismic Evaluation of Existing Buildings
A new method for evaluating the seismic resistance of existing buildings has been developed based on the historic performance of buildings in past major earthquakes. This methodology identifies...
ATC-22: Development of a Handbook for ATC-14
The ATC-22 project is the development of a Handbook for the application of the methodology of ATC-14 for the seismic evaluation of existing buildings. The development of the Handbook itself...
Consequences and Achievement of Supplemental Damping for Improved Seismic Performance
An earthquake resistant design philosophy which relies upon increased stiffness and damping rather than increased strength and ductility has been investigated. The effect of adding supplemental...
Earthquake Damage Estimates of Conventional and Isolated Structures
The philosophy inherent in current seismic design codes for buildings accepts the premise that there will be both structural and non-structural damage but that life safety will be preserved....
Friction-Dampers for Economic Seismic Design
A novel structural system, which combines the strength and stiffness of a braced frame and energy dissipation capacity of the friction-dampers, has been used in the design of a reinforced...
System Identification of Earth Dams Using Seismic Records
A technique to identify the elasto-plastic dynamic properties of earth dams and, therefore to asses the capabilities and limitation of their models, is developed. The technique is based...
System Identification of Meloland Road Overcrossing
The Meloland Road Overcrossing (MRO) is a two-span reinforced concrete bridge structure located east of El Centro, California, 0.3 mi from the Imperial Fault. The Imperial Valley Earthquake...
Some Significant Records from Instrumented Structures in California?USGS Program
The main objective in seismic instrumentation of structures is to facilitate response studies that lead to improved understanding of the dynamic behavior and the potential for damage to...
Seismic Instrumentation and Its Implication for High-Rise Buildings in Japan
An outline of the present state of the strong earthquake motions observation systems in Japan and an example of the obtained records of an earthquake and its simulation analysis of a high-rise...
Seismic Instrumentation of Buildings in Italy
The paper describes the philosophy of the ENEA project of seismic instrumentation of buildings in Italy and the steps made to implement it. The philosophy is twofold: i) to define a general...
Seismic Evaluation of a Tall Reinforced Concrete Frame Building
Accelerations at basement, fifth and tenth floor levels of a reinforced concrete apartment building were recorded during the October 1st, 1987 Whittier-Narrows earthquake. These accelerations...
Seismic Evaluation of PG&E Concrete Dams
Seismic evaluation of PG&E concrete dams is an ongoing process. The seismic environment for the dams changes over time because more historical earthquake data is obtained, faults...
Ductility and Failure Characteristics of Concrete and Rock Subjected to Complex Load Paths
Strength, ductility and the complex material response features of concrete and rock should be evaluated through carefully planned material properties test programs designed to subject...
Return to search