Study on Pneumatic Wave Power Conversion System with the Water Valve Rectifier
We experimentally and theoretically studied the energy conversion characteristics on a new type of wave power conversion system with water valves. The hydraulic model experiment was performed...

Research and Development of Wave Pump
A new device, 'Wave Pump' is introduced here. The authors present the mechanism of the system, the analytical method for discharge rate, the hydraulic model test...

Tidal Power Plants - The Source of Ecologically Clean Energy
This paper outlines the development of tidal energy within the Soviet Union (U.S.S.R.). It describes several working and proposed tidal power plants developed in the U.S.S.R. with a discussion...

Seawater Experimental Results of Direct-Contact Condensation for OC-OTEC Applications
Tests of a direct-contact condenser (DCC) for open-cycle ocean thermal energy conversion systems (OC-OTEC) have been conducted using seawater and exchanging up to 1.25 MWth...

A Semi-Empirical Model for an OC-OTEC Spout Flash Evaporator
A phenomenological model for the thermal-hydraulics of a spout flash evaporator is presented in this paper. The model considers the two-phase flow behavior both in the spout and in the...

Model for Nonlinear Behavior of Bolted Joints Under Bending/Tension Loading
A mathematical model to predict the load-deformation relationship of single-bolted connections in wood structures subjected to bending/tension loading is described. The model accounts...

Iterative Global/Local Finite Element Analysis
In spite of the advances in computer technology, there is still a need for more computationally efficient methods for performing stress analysis. One approach which is receiving increasing...

The ENF Test: Critical Analysis and Computational Modelling
We have developed an experimental and computational strategy to moderate the experimental scatter of the interlaminar fracture toughness values (GIIc)...

Rate Effects in the Deformation of Rocks
This paper gives a brief review of creep and rate effects on the behavior of rocks, within a wide range of confining pressures and temperatures, and with a special emphasis on the physical...

A Microplane Constitutive Model for Soils
A microplane model for the inelastic behavior of soils is presented. The microscopic constitutive equations are defined independentely for a set of microplanes covering all possible orientations,...

Creep of Polycrystalline Ice
This paper discusses the extension of creep models for polycrystalline ice to include the effects of a non-monotonic loading history. Attention is focussed on cyclic loading since it is...

An Extended Mixture Approach for Modeling of Fiber Reinforced Cementitious Materials
A rate-independent, anisotropic model for Fiber Reinforced Cementitious Materials (FRCMs) is presented. A continuum damage/plasticity model for the concrete and an effective fiber model...

Thermomechanical Damage Due to Hydration in Large Concrete Dams
This paper presents the bases of a thermomechanical model able to describe the main evolution of concrete properties with aging. The model is based on the 'maturity'...

Accurate Computation of Freezing Index
'Freezing index' (cumulative degree-days below freezing) is used for predicting frost penetration depths and modelling pavement performance. Contour maps which illustrate geographic trends...

Behavior and Strength of Telescopic Steel Shores
To study the load distribution between concrete floors and shores during construction, the non-linear axial load-shortening behavior of a single post shore must be modeled properly. In...

Stresses in Concrete Armor Units
This book is derived from a Seminar at the Waterways Experiment Station, Coastal Engineering Research Center, Vicksburg, Mississippi held on November 7-8, 1989. It presents a state-of-the-art...

Hydraulic Engineering
This proceedings consists of papers presented at the ASCE National Convention on Hydraulic Engineering given July 30 to August 3, 1990 in San Diego, California. The Conference provided...

Bridges on Screen
Computer software can help engineers produce designs for more economical, constructable bridges in less time than conventional methods. Software is being put to work in bridge design departments...

Stratified Flows
This volume contains the edited and refereed proceedings of the Third International Symposium on Stratified Flows, convened on February 3-5, 1987 in Pasadena, California. It consists of...

Effects of Uncertainties in Component Fragilities on Lifeline Seismic Risk Analysis
Accurate calculation of the seismic risk for lifelines requires modeling the system as a function of its components, and requires accurate modeling of two engineering factors: (1) the...

 

 

 

 

Return to search