Model Study of the Guadalupe River Bypass Culvert
A hydraulic model investigation of proposed channel improvements for the Guadalupe River Channel was conducted at the US Army Engineer Waterways Experiment Station in Vicksburg, Mississippi....
Experimental Research and Parameters Optimization of a Prototype OWC Wave Power Device
The paper presents the experimental research and parameters optimization of a prototype oscillating water column (OWC) wave power device being built in China by Guangzhou Institute of...
Study on Pneumatic Wave Power Conversion System with the Water Valve Rectifier
We experimentally and theoretically studied the energy conversion characteristics on a new type of wave power conversion system with water valves. The hydraulic model experiment was performed...
Research and Development of Wave Pump
A new device, 'Wave Pump' is introduced here. The authors present the mechanism of the system, the analytical method for discharge rate, the hydraulic model test...
A Semi-Empirical Model for an OC-OTEC Spout Flash Evaporator
A phenomenological model for the thermal-hydraulics of a spout flash evaporator is presented in this paper. The model considers the two-phase flow behavior both in the spout and in the...
The Future of Steel Structures
The future availability of steel as a construction material is covered in this paper. The advances in the material, design fabrication and erection are discussed. The quality and quantity...
Large Stone Hot Mix Asphalt: State of the Art
Improved mix characteristics can be achieved by utilizing existing well-known technologies. Developments have included: more attention to voids in mineral aggregate criteria; adjusting...
Large Stone Mixes Make a Comeback
Large stone hot mix asphalt common at the turn of the century, is making a comeback in popularity in hot mix asphalt design. Large stone hot asphalt mixtures are being used as a way to...
Protection of Wood Designs in Adverse Environments
Engineers and architects are becoming increasingly aware of the risks of poor wood design practices and the benefits of using wood properly. This paper addresses biological factors that...
Sawn Lumber in Bridge Construction
This paper covers many aspects of design and construction that affect the specifications of the sawn wood components of a highway bridge. The relationships between the grading rules for...
Glued Laminated Timber for Bridge Construction
Structural glued laminated timber (glulam) was first introduced into the U.S. as a construction material in 1934. With the development of fully waterproof adhesives in the 1940's,...
Premature Failures of Outdoor Masonry Pavements
The authors have investigated and repaired a number of premature inservice failures of masonry paving systems in recent years. These systems have become common, built over underground...
Repair of an Improperly Detailed Masonry Facade: A Case History
The masonry facade of an 18-story condominium building was constructed with an inconsistent pattern of shelf angle supports, marginal lateral restraints and without any horizontal control...
Design of Fiberglass Reinforced Plastic Underground Storage Tanks
The purpose of this paper is to discuss the design and construction techniques of fiberglass composite underground storage tanks. The scope of this paper is limited to the straight shell...
Three Tools for Design Test Bed Analysis
Three analytical tools are outlined for use in design test bed work focusing on the design/production interface. The tools are substitution analysis, coupling analysis, and value chain...
Effect of Fly Ash on the Microstructure and Durability of Concrete
The influence of fly ash on the microstructure and durability of concrete was investigated. It was found that the use of 50% fly ash in concrete reduced greatly its resistance to freezing-and-thawing...
Permeability Effects on the Sulfate Resistance of Concrete
A laboratory study was conducted to determine the effect of permeability on the sulfate resistance of concrete containing fly ash. Concrete specimens were moist cured for 7 and 100 days...
Experimental Mixes to Minimize Rutting
This report describes the materials and construction details involved in the design and placement of four experimental mixes on I-95 (Richmond-Petersburg Turnpike) in 1985 and follows...
Composite Applications in Highway Bridges
This report presents a summary of a four year research effort titled, 'Transfer of Composite Technology to Design and Construction of Bridges'. Extensive analytical...
Environmental Considerations in the Design of Asphalt Concrete Paving Mixtures
The design of asphalt concrete mixtures is largely based on two empirical mixture design methods. These are 'Marshall' and 'Hveem',...
Return to search