Piping Analysis: A Flexibility Approach
Design for the vertical and horizontal accelerations associated with a seismic event coupled with low allowable loads on equipment are two primary contributors to the current situation....

Composite-System Approach for Seismic Analysis of Secondary Systems
An accurate and efficient method for seismic analysis of multiply supported, multi-degree-of-freedom secondary subsystems is developed. The method accurately accounts for the effects of...

Sodium Concrete Reaction ? Structural Considerations
An overview of the sodium concrete reaction phenomenon, with emphasis on structural considerations, is presented. Available test results for limestone, basalt, and magnetite concrete with...

Reduction of Seismic Response in Breeder Plants
Thin-walled vessels to be used in the Nuclear Steam Supply Systems (NSSS) of future LMFBR's will be more sensitive to seismic excitation than their equivalents used in conventional...

Experimental Determination of Fluid-Coupling Coefficients in an Array of Hexagonal Prisms
The problem is related to the seismic analysis of fast breeder reactor cores, where the fluid trapped between the subassemblies is known to have a considerable influence on the core response....

Engineering Mechanics in Civil Engineering
The principles of engineering mechanics and the application of these principles to civil engineering problems cover a broad spectrum of topics ranging from theory to practice. These proceedings...

Centrifugal Modeling of Pile Foundations
Modeling of pile foundations in a centrifuge, where the self weight induced stresses in the soil are simulated by elevated gravity loading, is described. Hollow pipe piles in a stiff clay...

Prediction of Settlement of Single Piles in Clay
Analyses by trial were used to fit theoretical load-settlement curves to measured curves for driven piles. For the elastic method, analyses of load tests indicated that designers should...

Shaft Capacity of Driven Pipe Piles in Clay
A compilation of axial load test records for driven pipe piles in clay published by the American Petroleum Institute is analysed to yield new criteria for skin friction and pile scale...

Cyclic Degradation of Pile Performance in Calcareous Soils
Laboratory data on the skin friction of jacked or driven model piles is presented. Significant cyclic degradation of skin friction commences when the cyclic displacement amplitude reaches...

Residual Stresses in Piles and the Wave Equation
A data base of 18 vertical load tests on driven piles in sand is presented. On average the residual point load was 56% of the measured point load and the residual friction load 19% of...

Compression Load Tests on Concrete Piles in Alluvium
A series of tests was accomplished during the design phase for the West Seattle Freeway Bridge Replacement project. The results of instrumented compression load tests in alluvial deposits...

Evaluation of P-Y Relationships in Cohesionless Soils
Four semi-empirical procedures for construction of p-y curves in cohesionless soils were developed to fit data from a particular load test or a specific set of tests on similar soils....

Lateral Load Tests of Piles in Sloping Rock Fill
A new container wharf constructed at the Port of Los Angeles features vertical prestressed concrete piles to provide both vertical and lateral support. A rockfill embankment used to allow...

Pile Caps Subjected to Lateral Loads
This paper reviews current pile cap design practices and presents results of tests on two pile caps with different reinforcement locations. Lateral load tests performed on two pile cap...

Winkler Soil Model for Axial Response Analysis of Pile Groups
In this approach, the soil is idealized as a nonlinear Winkler model for a pile group attached to a group of piles. The model can account for pile-soil-pile interaction. Pile group responses...

The Simple-Pile Approach to Pile Installation in Clays
This article describes the fundamentals of the approach and presents solutions for the effects of quasi-static deep undrained penetration of a simple solid pile on the deformations and...

Pile Foundation Design Using Pile Driving Analyzer
A case history of pile foundation design and construction for Pacific Bell's San Ramon Valley Administrative Complex is presented. Dynamic monitoring of driven piles with...

Consolidation of Mining Wastes
This paper describes laboratory and field tests for determining consolidation properties of soft sediments, presents data on several types of mining wastes, and presents the results of...

Consolidation of Permafrost upon Thawing
Methods of predicting initial consolidation upon thawing and the subsequent consolidation with time under increasing pressures are presented in terms of changes in unit weight. Procedures...

 

 

 

 

Return to search