Comparing Bowen Ratio-Energy Balance Systems for Measuring ET
Two Bowen ratio-energy balance (BREB) systems for measuring evapotranspiration (ET) under wet and dry conditions were compared. The study sites were an irrigated grass sod near Kimberly,...
Standards for Automated Agricultural Weather Stations
A progress report is presented on American Society of Agricultural Engineers (ASAE) Standards Project X505: Measurement and Reporting Standards for Automated Agricultural Weather Stations....
Siting Agricultural Weather Stations
Studies were conducted in Arizona and Washington to investigate how the surrounding fetch affects data collected by agricultural weather stations (AWS). AWS surrounded by extensive areas...
Nongrowing Season ET from Irrigated Fields
The evaporative loss of water from agricultural fields during the nongrowing season is an important component of the annual water balance of irrigated lands. This study was conducted to...
Updating Utah's Crop Water Use Estimates
Crop water use was estimated at National Weather Service stations throughout Utah for the 1961-1990 normal period. Daily weather data (air temperature, solar radiation, humidity, wind...
Revision of Oregon Crop Water Use and Irrigation Requirements
A project to revise the crop water use estimates and irrigation requirements for the state at Oregon is described. The FAO modified Blaney-Criddle method was applied in this project since...
SCS Methods for Determining Irrigation Water Requirements
Technical Release No. 21 (USDA-SCS, 1970) has been used in the U.S. and around the world to design and manage irrigation projects. However, many advancements in predicting crop water use...
Streamflow Depletions and Water Transfers in Idaho
In the state of Idaho, streamflow depletions are quantified utilizing parameters of rate of flow, total volume diverted, and volume consumptively used. This paper summarizes the engineering...
Streamflow Depletions for Water Transfers in Utah
All inter- or intra-state transfers of Utah water rights must be accomplished by application and receive the approval of the Utah State Engineer. This paper summarizes the engineering...
Streamflow Depletions Considered in Water Transfers
In the State of Colorado, streamflow depletions are defined as that amount of water diverted to beneficial use minus return flows to the stream system. This paper summarizes the engineering...
Evaluating the Facts in Water Right Changes
Under the western system of appropriation water rights may be separated from the land and the time, type and place of use changed. Such changes are governed by the principle that there...
Streamflow Depletions Resulting from Ground Water Transfers
An application to move the point of diversion of a quasi-municipal ground water right from about 4.8 km to a second well about 0.3 km from a river channel was made in the Reno/Sparks,...
Hydrological Impacts of a California Water Transfer
Conaway Ranch, located in Yolo County, California, transferred water to the California Emergency Drought Water Bank (Water Bank) in 1991 and 1992. Water for these transfers was generated...
Water Transfer: Applicants and Objectors Analyses
Two different analyses of the historical on-farm consumptive use and return flows of agricultural water rights in Northern Colorado are discussed. The City of Thornton plans the transfer...
The ASCE Neutron Probe Calibration Study: Overview
A workshop was held at Logan, Utah to gather field information on neutron probe calibration and operation. Several techniques and instruments were compared. This paper serves to establish...
Soil Bulk Density Sampling for Neutron Gauge Calibration
The ASCE Task Committee on Neutron Gauge Calibration met in Logan, Utah in July 1992 to investigate the various methods of soil sampling, installation of access tubes, effect of various...
Measuring Soil Bulk Density Profiles with a Single Probe Gamma Density Gauge
Calibrating neutron depth gauges for measuring soil water content profiles requires soil bulk density data. In this study, the feasibility of using a single probe gamma density gauge to...
Error Analysis of Bulk Density Measurements for Neutron Moisture Gauge Calibration
Six bulk density sampling methods were evaluated for use in neutron gauge calibration. All six methods provided estimates of bulk density which were generally within 5% of bulk density...
Performance Factors of Neutron Moisture Probes Related to Position of Source on Detector
The performances of two commercially available neutron moisture probes with different source-detector placement were evaluated. The probes were the Troxler with the neutron source placed...
Neutron Gauge Calibration Comparison of Methods
Several methods for obtaining soil samples for determining soil water content were used for field calibration of neutron gauges. This paper compares the results of calibration curves obtained...
Return to search