Pre-Test Selection of Static Force and Displacement Measurement Locations for Damage Assessment
An incomplete set of static force and displacement measurements are used for parameter identification of linear elastic structures at the element level. Measurement locations and the level...
Parameter Estimation in Complex Linear Structures
We present a new parameter estimation method which simultaneously computes element constitutive parameters and unmeasured displacements of finite element models from measured static responses....
Bridge Overloading Criteria
Considerable concern is being expressed by the public and government agencies over the deteriorating state of the country's infrastructure. At the same time, there is a general feedling...
A Multiple Presence Load Model for Bridges
This paper utilises weigh-in-motion data to simulate multi-lane traffic crossing short span multiple-lane bridges. In this manner the reduction factors for a multiple lane bridge are derived....
Stabilizing Drop Structure by Drainage Modifications
East Drain Terminal Drop Structure is located in East Drain, an open toe drain of Palmetto Bend Dam, in the tide water area of south Texas. The drop structure was threatened by piping...
Retention Parameter Estimates for Curve Number Runoff Procedure
A technique is developed for computing estimates and associated probabilities of the retention parameter S in the Soil Conservation Service curve number runoff procedure. This technique...
Calculation of Runoff from Rainfall Using NURP Data
Peak runoff flows and flood hydrographs are important elements in the design of drainage and flood-protection structures. The validity of methods for predicting peak flow from rainfall...
Design of Latticed Steel Transmission Structures
This standard,
High Level Radioactive Waste Management 1992
The proceedings of the third International Conference on High Level Radioactive Waste Mnagement, held on April 12-16, 1992, Las Vegas, Nevada, provides information on the technical and...
A Monumental Task
The geotechnical consultants, structural engineer and contractor combined to overcome difficult soils, underground subway structures and buried utilities when building the foundations...
Taming Tornado Alley
Some structures�such as nuclear power plants�need complete protection from tornadoes regardless of the high costs of design and construction. Public facilities need protection too, but...
New Cruise Terminal for San Francisco
A new international Cruise Terminal is being developed at Pier 30-32 in San Francisco, to replace present inadequate facilities at Pier 35. The Cruise Terminal will be developed as part...
On-Off Terminal Ship-to-Rail Transfer
The intermodal situation of U.S. ports is still evolving, and port planners will be facing difficult decisions regarding IM Configurations. This article was intended to assist 'perplexed'...
Port of Portland's Berth 601 Floating Dock
The Port of Portland's facilities, being located on the Columbia and Willamette Rivers, are subjected to extreme water level fluctuations. Over the years, the Port has used floating docks...
Analysis of a Wharf for a Container Terminal
A balanced combination of sophisticated computer programs was employed to model the soil strata, foundation and structure of a wharf for a new container terminal in the Port of Topolobampo,...
Deep Water Container Wharf & Crane Foundation
A deep water anchored steel bulkhead and a parallel-independent low-profile, pile supported crane rail foundation with special stowage areas are discussed from soils investigation, through...
Case Study ? Elliott Bay Marina Floating Moorage
The recently completed Elliott Bay Marina project in Seattle is one of the larger projects of this type in the country, with 1196 slips ranging from 32 feet to 60 feet, a floating fuel...
Batter Piles and the Seismic Performance of Pile-Supported Wharves
This paper discusses the role of batter piles in the seismic performance of wharves, based on the results of a nonlinear soil-structure interaction analysis of a pile-supported wharf with...
Riprap Design in Marine Terminals
Navigation vessels in otherwise quiescent waterways sometimes generate forces that require stabilization of the bed or banks. Since riprap is an accepted and dependable means to armor...
Non-Intrusive Rayleigh Wave Measurement System for Soil Profiling in Ports
Accurate shear wave velocity profiles have been long recognized as essential data to evaluate the dynamic response of soil deposits and soil-structure interaction under earthquake and...
Return to search