Synchronized Measurements of Bed-Shear Stress and Flow Velocity in Open Channels with Simulated Vegetation
Synchronized measurements of shear stresses at the bed and velocities both within and above a simulated plant canopy in an open-channel flow are presented. Traditional (hot-film sensors)...
Propeller Wash Induced Erosion at Quay Walls
The characteristics are examined of the sea bed erosion produced by the scouring action of a ship's propeller wash acting against a quay wall. The rate of development of erosion...
Fish Passage Pool Bedding Analysis
Anadromous fish passages, stream dynamics and the artifical channel segmented into a natural stream should fttnction seamlessly. This paper intends to develop reasonable procedures a designer...
Scour Protection in Bottomless Culverts
This paper will describe the relative severity of scour anticipated to occur at bottomless culverts and will provide some design guidance for scour protection based on research referenced...
Study of Hydraulic Jump Lengths on Inclined Channel Beds
A hydraulic jump is generally used to dissipate kinetic energy of flow to protect man-made structures such as spillways, drop structures, and outlet works. It serves as a perfect location...
Review of Cold-Formed Steel Purlin Design
The use of cold-formed steel members as roof purlins for single story industrial and commercial buildings is commonly recognized. These members typically have either a C- or Z-shaped cross...
How to Optimize Light-Gage, Cold-Formed Steel Beams
The Illustrative Examples section of the AISI Cold-Formed Steel Design Manual (AISI 1989) demonstrates how to analyze a number of different cold-formed steel sections. This paper applies...
A New LAX-WENDROFF Algorithm to Solve the Bed Continuity Equation With Slope Effect
The numerical simulation of mobile bed evolutions of seas, estuaries and rivers requires a morphological model, including the effects of waves, currents and sediment transport, as well...
Vadose-Zone Monitoring, Sanitary Treatment Plant Sludge-Drying Beds, Rocky Flats Plant, Golden, Colorado
The NPDES Federal Facilities Compliance Agreement (NPDES FFCA) of March 25, 1991 between the U. S. Department of Energy (DOE) and the U. S. Environmental Protection Agency (EPA), pursuant...
Prediction of Gravel Bedload with SAM
Bedload measurements for Little Beaver Creek in Colorado were used to test the sediment transport functions included in SAM. The test results showed that Toffaleti predicts total bedload...
Biological Upflow Fluidized Bed Denitrification Reactor Demonstration Project-Stamford, Ct.
Results of a demonstration project using a biological upflow fluidized bed reactor to remove nitrogen from wastewater treatment plant effluent are described. The reactor was operated at...
The Evaluation of Empty Bed Contact Time on the Biodegradation of Pentachlorophenol using an Anaerobic GAC Fluidized Bed
The objective of this research is to evaluate the effects of decreasing the empty-bed contact time (EBCT) on pentachlorophenol and its intermediates utilizing an anaerobic granular activated...
Biodegradation of 2,4-Dinitrotoluene in a Two Stage System
An anaerobic/anoxic fluidized-bed GAC bioreactor in series with an activated sludge reactor was used to treat 2,4-Dinitrotoluene (2,4-DNT). A simulated high strength wastewater solution...
NCASI Experiment Related to Validation of Equilibrium Partitioning (EP) Theory
A review of NCASI's technical studies related to evaluating equilibrium partitioning (EP) theory as it is commonly applied in regulatory setting is presented. Although interim results...
Calibration of Movable Bed Model for Armant Area
The morphology of the Nile River, in Egypt, is undergoing continuous changes which causes navigation bottle-necks in some local reaches. About 200 km downstream Aswan, at Armant area,...
Using the SedBed Monitor to Measure Bed Load
An acoustic distance measuring device (SedBed Monitor) was developed to accurately measure bed surface transects in a sediment and water recirculating flume. From these transects the rate...
Vertical Sorting Within Dune Structure
Sediment transport occurs in natural stream beds at least in part as bed load. These bed forms are typically classified as ripples or dunes depending on the bed morphology and flow conditions....
On Measurements of Particle Spinning Motion
Investigation of particle saltation motion is crucial to the development of the theory of bed load transport. Due to the combination effects of the bed roughness and the velocity gradient,...
Response of Velocity and Turbulence to Abrupt Changes from Smooth to Rough Beds in Open-channel Flows
Response of velocity distribution and turbulence characteristics to abrupt changes of bed roughness have been investigated experimentally with two-component laser Doppler anemometer (LDA)....
Visual Investigation of Field Bed-Load Sampling
An instrument for bed load sampling was developed consisting of an underwater video camera for visual observations. This instrument is called the Delft-Nile sampler and its design, efficiency...
Return to search