Field Monitoring of a Modular Detached Breakwater System
A pair of modular concrete detached breakwaters was installed at a site on the New Jersey shore. This paper describes an eighteen month field monitoring program of the beach response to...
Bay Ridge, Anne Arundel County, Maryland Offshore Breakwater and Beach Fill Design
Construction of the Bay Ridge shoreline protection project was completed in July 1991 and consists of eleven offshore segmented breakwaters with beach fill. The breakwaters, located about...
Design of Protective Dunes at Dam Neck, Virginia
Dunes act as a primary coastal defense against inundation in the Netherlands and the Dutch Government has devoted considerable effort towards development of reliable procedures for the...
Articulating Block Mat Revetment for Whaler's Village
The desire of homeowners to live along the California coastline presents the engineer with many unique design opportunities and constraints. Housing built atop coastal cliffs and bluffs...
Coastal Processes and Engineering on a Micronesian Fringing Reef
In 1980, portions of the fringing reef flat protecting the village of Tafunsak, Federated States of Micronesia, were dredged to provide fill material for an airport runway access road....
Laupahoehoe Harbor Planning, Design, & Construction
Laupahoehoe Harbor provides access to the fertile fishing grounds along the northeast or Hamakua coast of the island of Hawaii, Hawaii. The planning, design, and construction of Laupahoehoe...
Reformulation Efforts for Panama City Harbor, Florida
Panama City Harbor is on St. Andrew Bay, an arm of the Gulf of Mexico, about 105 miles east of Pensacola and 230 miles northwest of Tampa. At the request of the non-Federal sponsor, the...
Numerical Modeling of Proposed Kawaihae Harbor, HI
The Kawaihae shallow-draft harbor site is located on the northwest coast of the island of Hawaii, HI. An entrance channel, turning basin, and breakwater currently exist at the harbor site....
Wave Barriers: An Environmentally Benign Alternative
This paper describes the history and development of the environmental wave barrier and the current planning and design being undertaken for a major expansion of the small boat harbor at...
Design, Construction, and Performance of a Baffled Breakwater
The Spud Point Marina breakwater is located within Bodega Harbor, a protected embayment on the northern California coast. Waves are attenuated by baffle panels hung between support piles....
57 Years of Coastal Engineering Practice at a Problem Inlet: Indian River Inlet, Delaware
This paper presents a review of Indian River Inlet's behavior in its natural state prior to jetty construction and summarizes the level of understanding of coastal processes and inlet-bay...
An Engineering Assessment of Hydrodynamics and Beach Response at Little River Inlet, NC-SC
The Waterways Experiment Station's (WES) Coastal Engineering Research Center (CERC) conducted an analysis for the U.S. Army Engineer District, Charleston (SAC) of the monitoring data collected...
Investigation of Coastal Conditions at Oregon Inlet, NC for the Replacement of the Herbert C. Bonner Bridge
The Bonner Bridge across Oregon Inlet was constructed in 1962 and is approaching the end of its service life. Planning for a future crossing must consider natural inlet migration expected...
Design and Construction of Shinnecock Inlet, New York
Shinnecock Inlet is the easternmost of six coastal inlet which bracket the barrier island on the south shore of Long Island, New York. Through recent history, Shinnecock Inlet has exhibited...
Scour Hole Development and Stabilization at Shinnecock and Moriches Inlets, New York
A scour hole developed inside the Shinnecock Inlet channel near the tip of the west jetty. Over the years, this hole deepened to about 70 ft below the mean low water level with the average...
South Jetty Scour Hole Stabilization, Ocean City, Maryland
Formation of a scour hole along the inlet side of the South Jetty at Ocean City occurred after jetty construction as a result of ebb tidal flow in the inlet. Analysis of historical bathymetry...
Use of Portable Simulator in Designing Channel Improvements for Port of Brownsville, Texas
The Port of Brownsville, located at the southernmost tip of Texas, serves as an import/export port for both southern Texas and northern Mexico. The proposed channel improvement project...
Alternative Study for the Breakwater and Fishing Pier Rehabilitation at Playland Park, Rye, New York
An alternative study was conducted to determine that existing condition of a deteriorated timber pier and a rubblemound breakwater, and to develop alternative rehabilitation plans leading...
Sylvan Beach Pier Rehabilitation Study
The Sylvan Beach Pier is a navigation guide jetty located at the east and of Oneida Lake in Oneida County, New York. It protects the entrance to the New York State Barge Canal which crosses...
Naval Pier Foundation Design and Construction, Pearl Harbor, Hawaii
The paper presents a case study of foundation design and construction for a pier in Pearl Harbor. The study covers a review of site investigations, laboratory testing, pile selection and...
Return to search