Relationships between Shear Wave Velocity and Depth of Overburden
Relationships between in-situ shear wave velocity and depth of overburden have been derived for various Quaternary age soils encountered primarily in Southern California. The geotechnical...
Behavior of Drilled Piers in Layered Soils on Texas Barrier Islands
Twenty-eight full scale load tests and the results of 41 geotechnical studies were analyzed to correlate shear strength interpreted from field and laboratory test data with those derived...
Simulation of Hillslope Hydrologic Response to Snowmelt in Southwestern Idaho
A two-dimensional, variably saturated porous media flow model was applied to vertical hillslope cross section on a first order study basin in southwestern Idaho. The dominant source of...
Landslide Hazard Rating for the Oregon Coast Range
The landslide hazard rating system for shallow soils on steep terrain over hard sandstone has three components: ground water response to precipitation, soil shear strength (including root...
The Role of Multiple Level Hydrologic Analysis in Watershed Management?A Case Study in Trinidad
An accurate estimation of peak flood flows and its correlation with existing and future land use are basic requirements for the scientific management of Watersheds. An accurate estimation...
Prediction of Soil Water Properties for Hydrologic Modeling
Water flow in soils can be characterized for many boundary and initial conditions by solving governing differential equations. Thus, a physically consistent means of quantifying water...
Source Area Variability During Peakflow: A Function of Antecedent Soil Moisture Content
An attempt was made to identify the source areas contributing to peakflow and to quantify the relative importance of each source area under various antecedent soil moisture (ASM) conditions....
A Systematic Evaluation of Hillslope Subsurface Flow: The Effects of Slope Angle and Soil Parameter Variation
A two-dimensional finite element variably saturated flow model is used in conjunction with an automatic mesh generating scheme to simulate hillslope subsurface flow. Slopes from 2% to...
Abutment Seepage at Smithville Dam
After initial filling there was concern for the stability of Smithville Dam when higher than anticipated piezometric levels were experienced in the left abutment foundation. Concern heightened...
Seepage in the Unsaturated Zone: A Review
This paper briefly reviews the procedures whereby the seepage rate, depth of penetration of nonreactive pollutants, and the depth of the wetting front can be calculated when the assumption...
Use of Asphalt in Treatment of Dam Foundation Leakage, Stewartsville Dam
This paper presents the recent development and application of a hot asphalt grouting technique used to stop a 5,000 Imperial Gallons Per Minute (IGPM) (22,000 lpm) dam leakage under full...
Computer Applications in Grouting
The first use of computers during foundation grouting was tried by the Bureau of Reclamation on Ridgeway Dam in Colorado. It was very useful in monitoring real time down hole conditions...
Acoustic Emission Monitoring of Grout Movement
This paper describes the acoustic emission (AE) method in general, and in particular the AE system which holds significant promise in this regard. Used was a multichannel AE system which...
Grout Slurries?Thick or Thin?
In this paper some recent experiences in dam grouting in several countries are discussed where bentonite or Intraplast additives were used to control sedimentation, viscosity, grout density,...
Bond Stress of Embedded Steel Shapes in Concrete
This paper describes an investigation into the bond stress developed between steel shapes and reinforced concrete when the concrete is lightly stressed. A brief discussion of previous...
Shear Strengths of Concrete-Filled Steel Box Elements
This study evaluated the ultimate strengths as well as the effect of the ultimate composite actions of concrete-filled steel composites under combined bending, shear, and axial forces....
Composite Columns?Design and Examples for Construction
The new German standard DIN 18806, part 1 gives the rules for the design of composite columns. The general method, taking into account all the inhomogeneties of the two materials steel...
Design of Framed Steel Structures with Infill Reinforced Concrete Walls
It is a well-known fact that an infill shear wall in a frame acts as a compressive diagonal strut, giving strength and inflexibility to the frame. Recently the Architectural Institute...
Mathematical Modeling of Ground Water Flow
Many numerical algorithms for ground water flow models have been published and are available in computer software packages. It is the job of the ground water specialist to select an appropriate...
Simulation of Groundwater Flows in Leaky Multi-Layered Aquifer
A newly developed computational methodology for simulating the groundwater flows in multi-layered aquifer is presented. The model is based on the finite element method following the Galerkin's...
Return to search