Analysis of Soil-Stress Cell Interaction
Static loading experiments conducted on a soil stress cell embedded in a sand are presented. Stress cell performance was evaluated by comparing the indicated stress against the expected...
Visco-elasticity and the Compressive Failure of Polycrystalline Ice
The analysis of the visco-elasticity of polycrystalline ice is addressed. Experimental results on isotropic and anisotropic polycrystalline ice are presented, which indicate that intracrystalline...
Anelastic Straining in Polycrystalline Ice
This paper presents experimental observations on the influence of stress, grain size and total strain level on the magnitude of anelastic strain in granular freshwater ice. Cyclic loading...
Microstructure and Mechanical Behaviour of Ice
Short descriptions are given for ice in nature, test methods used to evaluate their deformation behaviour and, a general microstructure-based constitutive equation. Equations suitable...
Fractal Crushing
This paper develops an approach to a two-dimensional fragmentation process, in which floating ice floes are driven against each other and break up into smaller floes. It first considers...
Effect of Grain Size Variation on Damage in Polycrystalline Ice
This paper studies the effect of grain size distributions on damage accumulation in polycrystalline ice under uniaxial compression. The numerical results are derived from the internal-variable...
The Ductile-Brittle Transition in Ice & Size Effect
This paper considers the ductile to brittle transition in ice under compression. Two criteria, one phenomenological and the other more physical, are presented for the transition strain...
Preliminary Results of Direct Tension Tests on First-Year Sea Ice Samples
We present the initial results of our tests to determine the tensile behavior of columnar sea ice over a range of temperatures extending from -20 to -3?C and strain rates of 10-5...
Fracture Resistance to Cracking in Ice: Initiation and Growth
The issue of notch sensitivity and brittleness of the test failure is used to forecast the necessary specimen size for a material property initiation toughness; a methodology is developed...
Size Effects in the Fracture of Quasi-Brittle Materials
Causes and influences of the structural size effect that is exhibited by materials such as concrete, mortar, ice rock and ceramics, are discussed. The size effect law, which models this...
Laboratory Observations of Macroscopic Failure Modes in Freshwater Ice
A review is presented of tests performed in the laboratory by several investigators on indentation in freshwater ice. A number of the observed failure modes are discussed. From the results,...
Effective Pressures Measured During Indentation Tests in Freshwater Ice
Indentation tests were conducted by pushing flat, vertical indentors of two different widths (50 and 100 mm) against the edges of floating, freshwater ice at different velocities (0.6-150...
Snow Fence Operational and Material Testing
The proliferation of snow fence products since the late 1970's presents an opportunity for optimizing the control of drifting snow. It also presents a challenge in discriminating...
Recommended Cold Regions Meteorological Instrumentation
For nearly 30 years, CRREL has studied environmental conditions in winter weather. These efforts have concentrated on providing field-measured meteorological data and historical climatological...
Earth Walls: Making the Right Choice
Earth walls are retaining walls where the ground assumes a load-bearing role. These walls either support compacted earth (embankment-type reinforced compacted earth walls such as Doublewal...
Design of Large Capacity Coal Silos for Service Life
Design and construction of Large Capacity Coal Silos for service life requires a careful consideration of the silo configuration as well as the material handling system. This paper presents...
Improved Corrosion Protection for Flue Gas Systems Utilizing a Dual Liner Concept
A unique system of corrosion resistant materials has shown excellent performance and durability in flue gas systems for fossil plants, cogeneration plants, waste incinerators and waste-to-energy...
Designing for Corrosion Control
This presentation will discuss designing from several aspects: a. Designing of the item to lessen the affects of corrosion. b. Selection of non-corrosive materials in the designing process...
Procedure for Seismic Evaluation and Design of Small Bore Piping
Simplified methods for the seismic design for small bore piping in nuclear power plants have been used for many years. Various pipe designers have developed unique methods to treat the...
Introduction to Structural and Mechanical Failure Modes for Nuclear Power Facilities
The three papers presented in this section discuss the types of information (i.e., dynamic tests, earthquake experience and analytical data) which are used in predicting the capacity of...
Return to search