Cyclic Degradation of Pile Performance in Calcareous Soils
Laboratory data on the skin friction of jacked or driven model piles is presented. Significant cyclic degradation of skin friction commences when the cyclic displacement amplitude reaches...
Residual Stresses in Piles and the Wave Equation
A data base of 18 vertical load tests on driven piles in sand is presented. On average the residual point load was 56% of the measured point load and the residual friction load 19% of...
Compression Load Tests on Concrete Piles in Alluvium
A series of tests was accomplished during the design phase for the West Seattle Freeway Bridge Replacement project. The results of instrumented compression load tests in alluvial deposits...
Vertical Behavior of Two 16-Year Old Drilled Shafts
Vertical load tests were performed on drilled shafts subject to lateral confining and heaving pressures from expansive soil over 16 years. Results indicated mobilized skin friction equal...
Evaluation of P-Y Relationships in Cohesionless Soils
Four semi-empirical procedures for construction of p-y curves in cohesionless soils were developed to fit data from a particular load test or a specific set of tests on similar soils....
Evaluation of P-Y Relationships in Cohesive Soils
The practice of analyzing laterally loaded driven and bored piles often requires modeling of soil response in terms of uncoupled, non-linear unit load transfer functions. These functions,...
Lateral Load Tests of Piles in Sloping Rock Fill
A new container wharf constructed at the Port of Los Angeles features vertical prestressed concrete piles to provide both vertical and lateral support. A rockfill embankment used to allow...
A Flat-Dilatometer Study of Lateral Soil Response
The effect of flat dilatometer penetration on the lateral stress conditions in soil around the dilatometer blade and the soil response against dilatometer diaphragm deflection were investigated...
Pile Caps Subjected to Lateral Loads
This paper reviews current pile cap design practices and presents results of tests on two pile caps with different reinforcement locations. Lateral load tests performed on two pile cap...
Dynamic Stiffness of Pile Groups
A number of procedures have been proposed for the dynamic analysis of complete pile foundations including group effects. Most of these introduce some sort of approximation to reduce the...
Winkler Soil Model for Axial Response Analysis of Pile Groups
In this approach, the soil is idealized as a nonlinear Winkler model for a pile group attached to a group of piles. The model can account for pile-soil-pile interaction. Pile group responses...
The Simple-Pile Approach to Pile Installation in Clays
This article describes the fundamentals of the approach and presents solutions for the effects of quasi-static deep undrained penetration of a simple solid pile on the deformations and...
Pile Foundation Movements During Construction
Two case histories concern a shipyard wharf and work bay in Los Angeles harbor and an oil refinery expansion in Sumatra, Indonesia. The case histories provide further data on the nature...
Pile Foundation Design Using Pile Driving Analyzer
A case history of pile foundation design and construction for Pacific Bell's San Ramon Valley Administrative Complex is presented. Dynamic monitoring of driven piles with...
Role of a Standard in the Production of Drilled Shafts
The preparation of drawings and documents that describe the details of the installation of drilled shafts for a project requires an up-to-date standard. The role of the standard in the...
Geotechnical Perspective?Proposed Drilled Shaft Standard
In the writer's understanding, a standard is an agreed upon manual of practice and as such, sets the level of performance and attainment considered adequate. A standard is...
A Structural Engineering Perspective for Drilled Shafts
This commentary is an attempt to close the gap between the Building Code Requirements for Reinforced Concrete (ACE 318-83) and the design of drilled shafts. The context of design includes...
Computer Aided Design of Reinforced Concrete
An interactive computer-aided design (CAD) program for the design of reinforced concrete members is herein described. The program, called ECPRS, designs reinforcement and performs all...
Pavement Recycling: Stopgap or Remedy?
Recycled pavements cost less than new asphalt concrete overlays, but no long term data has ratified how recycled pavements' strength and durability compare to virgin material....
RCC Dam Incorporates Innovative Hydraulic Features
An overview of the features of Monksville Dam is presented, with emphasis on the hydraulic components of the project. This 150-foot (45-meter) high roller compacted concrete structure...
Return to search