Environmental Geotechnology & Tailings Reclamation
The Department of Energy is responsible, in terms of Federal Legislation, for remedial action work at 24 inactive uranium mill tailings piles in ten states. This paper describes the setting...
Reclamation of Athabasca Oil Sand Sludge
The bulk of oil sand tailings (80 to 90%) consists of quartz sand, which is defined to be everything coarser than 44 microns. The other 10 to 20%, termed 'sludge',...
Flow and Mass Transport for Hazardous Waste Liners
Certain aspects of flow and contaminant migration of hazardous liquids through soils are addressed. A fine-grained soil and fluids commonly encountered in hazardous sites, were considered....
Field Measurements of Landfill Surface Settlements
The Collier Road Landfill, located in southeast Michigan, has been accepting industrial and muncipal solid waste since the late 1960's. This existing landfill encompasses...
Analysis of Plastic Soil in Contact with Cavitose Bedrock
A numerical analysis has been conducted to evaluate the stress deformational response of highly plastic soils in contact with cavitose Bedrock. The numerical idealization represents the...
Hazardous Waste Landfill Cap System Stability
Pursuant to the regulatory requirements for control of rainfall infiltration into a hazardous waste landfill, a cap design that is impervious plus stable is required. The intent of a cap...
Fly Ash as a Potential Waste Liner
Earthen liners have been widely used to contain toxic and hazardous materials in ponds and landfills. There is close scrutiny over the durability of liners in contact with various wastes...
Plastic Concrete Cutoff Walls
The studies revealed that plastic concrete can be prepared having a coefficient of hydraulic conductivity that is less than 1 multiplied by 10** minus **7 cm/sec. The shear strength of...
Test Fill for a Double Liner System
A double liner system is required in hazardous waste disposal facilities to satisfy the current Resource Conservation and Recovery Act and State of Michigan Act 64 Requirements. To meet...
Design and Performance Monitoring of Clay-Lined Landfills
The use of thick clay liners has been applied to Wisconsin landfills for over a decade. Currently, there are over 35 solid waste disposal facilities in Wisconsin which have been constructed...
Acceptance Sampling for Clay Liner Design
The assurance of the quality of constructed clay liners has been a problem for geotechnical engineers. Compliance with minimum standards is necessary to ensure the liner performance capability....
Influential Factors in Soil Liner Construction for Waste Disposal Facilities
Those factors most influential in the construction of a soil liner to meet a permeability performance standard of 1 multiplied by 10-7 centimeters per second (cm/sec) are identified and...
Automated Permit Review for Hazardous Waste Surface Impoundments
The United States Environmental Protection Agency has proposed to develop automated permit review for RCRA hazardous waste surface impoundment facilities. The review automation will consist...
Evaluation of Compacted Inert Paper Solids as a Cover Material
The following paper presents the results of a laboratory test program which focused on compacted sludges or inert paper solids (IPS) as recommended cover (cap) material over existing IPS...
Hydrogeologic Investigations at a Superfund Site in Wisconsin
An estimated 10,000 drums of volatile organic wastes from a nearby manufacturing plant were dumped at a landfill site in southern Wisconsin. Chemicals released from these drums have contaminated...
The Use of Cone Penetration Testing for Evaluation of Waste Disposal Alternatives
Geotechnical information derived from cone penetration testing (CPT) has been found to give increased accuracy in the siting of waste disposal facilities and in the design of remedial...
Shallow Ocean Disposal of Contaminated Dredge Material
The contaminated dredged materials from harbors and waterways along heavily populated coastal areas such as Connecticut must often be disposed at shallow ocean sites. To isolate the contaminants...
Hydrocarbon Refining Waste Stabilization for Landfills
Mobile pollutants are generated in a landfill as a function of the waste properties and the response of the deposit to the in-situ stress, climate and biochemical conditions. Release of...
The Typical Engineering Properties of Fly Ash
Knowledge of key physical and engineering properties of coal fly ash is needed in the planning, design, and construction of both disposal and utilization projects. While considerable data...
Evaluation of Waste Disposal Sites Using Geotox
GEOTOX is a knowledge-based expert system designed to assist in the identification and classification of waste disposal sites. Existing methodologies such as formal or qualitative risk...
Return to search