An Ongoing Investigation of Residual Suspended Material Transport in Central San Francisco Bay, CA
A study of suspended material transport in San Francisco Bay, California, is presently underway by the U.S. Army Corps of Engineers. This paper describes preliminary numerical model and...
Hydraulics of Side-Channel Weirs for Regional Detention Basins
Side-channel weirs can be used for diversion to reduce flood peaks. A 1:25 scale model was built to investigate the hydraulic characteristics of embankment-shaped side-channel weirs. Results...
Climate Change and U.S. Water Resources: Results from a Study by the American Association for Advancement of Science
The time horizon of the changes that might occur is similar to the time required for planning, approval, funding, construction and economic life of such major water facilities as dams,...
Prediction Using Geostatistics and Mathematical Models
This paper discusses a new interpretation of geostatistical estimation and presents some thoughts on the meaning of probabilities in geostatistics and the role of mathematical models of...
Design of Expansions for Sub-Critical Open Channel Flow
Expansions for open channel flow at sub-critical velocity are required whenever it is necessary to reduce the velocity of flow from a structure which discharges into an erodible channel....
Borden Field Data and Multivariate Geostatistics
A large-scale field experiment on natural gradient transport of solutes in groundwater was conducted in an unconfined sand aquifer in Borden, Ontario by extensive monitoring after the...
Conditional Simulation of the Wilmington Sand-Shale Sequence, Los Angeles Basin
In shaly clastic reservoirs at a scale where vertical cross flow cannot be ignored the main source of heterogeneity is the apparent random geometry of the sand-shale sequence. That geometry...
Two Case Studies of Stochastic Identification of Aquifer Hydraulic Parameters and Natural Recharge
A method to identify aquifer transmissivity, storativity and natural recharge (inverse modeling), based on a geostatistical approach is presented. The basic assumptions of the method are...
Scale Effects at Intakes Due to Boundary Layer Growth
Boundary layer development in hydraulic models of intakes based on Froude criteria can be poorly scaled because it is viscosity dependent. The potential for scale effects can be estimated...
Model Study of New Madrid Pumping Station
The proposed pumping station on the New Madrid Floodway consisted of a draft tube type sump design (referred to as a formed suction inlet) to eliminate swirl and provide a more uniform...
Self-Aerating Spillway Flow
The concept upon which most past analyses are based is that a continuum exists in aerated flow from 100 percent water, to air bubbles in water, to a water-air mixture, to an air-water...
Two-Dimensional Inter-Rill Flow Model for the Analysis of Agricultural Runoff
This paper presents a model describing the flow field for the inter-rill component of agricultural runoff. Given rainfall intensity, surface roughness, rill spacing, and longitudinal and...
Sediment Basin Design Using 2-D Techniques
A set of procedures for the design of sediment basins is outlined; it is based on two-dimensional hydrodynamic analyses, in contrast to conversional practice which has used only one-dimensional...
Energy Dissipation Structure for Fixed-Cone Valves
Results of a model study to investigate the hydraulic performance of a proposed energy dissipation structure for fixed-cone valves are presented. Procedures for estimating pressures and...
A Numerical Analysis Approach to the Solution of Unsteady Flow in Open Channels
Several inherent characteristics of all current numerical simulations of the unsteady flow equations prevent total confidence in their use. Inconsistencies within the numerical procedures...
Grid Requirements for Numerical Models Containing Training Works
The numerical modeling of the rapid changes in flow variable in open channel flow systems containing training works, such as dikes, requires special attention in grid development. This...
A
A two-component turbulence model is introduced for depth-average flow calculations in shallow open-channel flows. This model treats the bed-generated turbulence as a background component,...
High-Resolution Two Dimensional Advective Transport
The paper describes a two-dimensional high-resolution scheme for advective transport that is based on a Eulerian-Lagrangian method with a flux limiter. The scheme is applied to the problem...
Numerical Prediction of the Turbulent Flow with a Free Surface for 3-Dimensional Situation
An efficient finite-difference method, the HH-SIMPLE, has been developed that is based on a new concept of hydraulic pressure with two additional equations concerning the water surface...
Far-Field Numerical Model Studies for Boston's New Secondary Treatment Plant Outfall Siting
By the late 1900s, Boston is scheduled to have built a new secondary treatment plant that combines the waste streams from two existing plant, and discharges the resulting liquid effluent...
Return to search