ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Bed Load Prediction in Steep Mountain Rivers
The characteristics of the stream channel morphologies in a very steep mountain ravine are explained by the data obtained through the longterm field observation. The bed load transportation...

Step-Pool Streams: An Adjustment to Maximum Flow Resistance
An experiment was conducted to study the maximum flow resistance of step pool streams and the morphology of the steps formed from clastic materials. The step pool formation was qualitatively...

A General Theory of Channel Adjustment in High Gradient Streams
The paper presents a theory of channel adjustment in high gradient streams. This theory states that given sufficient energy, stream channels will adjust their dimensions and flow hydraulics...

Step Pool Geometry and Flow Characteristics in Low-Sediment-Storage Channel Beds
Data from two small ephemeral streams in Israel indicate that step pool geometry in bedrock channels is similar, in its salient features, to that in alluvial channels. For steep (>0.10)...

A Mechanism of Pool Formation and Maintenance in Forest Streams
Laboratory and field investigations illustrate a hydraulic mechanism responsible for the formation and maintenance of pools associated with large, in-channel obstructions in forest streams....

Analysis of blocking phenomena in bifurcated channels found in mountainous rivers
The paper presents an analysis of blocking phenomena in bifurcated channels found in mountain rivers. A change of channels may be caused by deposition of sediments which blocks the entrance...

Estimating Local Bed Shear Stress in Large Gravel-Bed Rivers
The local bed shear stress ?_o1 cannot be directly measured and is typically estimated using flow observations in various theoretical or empirical...

Turbulent Velocities in a Mountain River
A weighted, electronic Pitot tube was deployed in the swift, boulder-bed Waiho river during a 46 m³/s flow and a 214 m³/s...

On Habitat Simulation in Mountain Rivers
Mountain rivers are quite different from other rivers and one of the characteristics that distinguish them from others is the large variation in velocities with time, with location in...

Coarse Sediment Transport and the Maintenance of Fish Habitat in the Upper Colorado River
An analysis of the relation between discharge and boundary shear stress is presented for an alluvial reach of the Colorado River near Grand Junction, CO. The analysis indicates that the...

Palaeohydraulic reconstruction of floods in upland UK bedrock streams: progress, problems and prospects
Palaeoflood evidence from five small upland Pennine catchments in the UK is used with the HEC-2 flow routine to simulate Holocene peak discharges. Even allowing for uncertainty, sensitivity...

Streamflow Related to Channel Geometry in Northern New England
Channel geometry measurements can be used to estimate various streamflow characteristics at ungaged stream locations. Channel cross section dimensions and sediment size distributions were...

Relation Between Largest Known Flood Discharge and Elevation in Montana
Previous studies relating unit discharge to elevation indicated that large floods in the Rocky Mountains may be limited by elevation. However, high-elevation data are sparse in Montana...

Historic-Flood Evaluation and Research Needs in Mountainous Areas
An evaluation of historic flood estimates in mountainous areas in Colorado was made to assess their accuracy. The purpose of this evaluation is to enhance awareness of the need to assess...

Ambrose, R. B.
Numerous three-dimensional hydrodynamic models have been developed in the last two decades. The developers of each model have used their own methods to verify the codes before applying...

PSF-PM Verification of 3D Free Surface Flow Models
This paper reports an application of the Prescribed Solution Forcing (PSF) and Physical Modeling (PM) to the development of a systematic procedure for the verification of three-dimensional...

3D Free Surface Flow Model Verification - A Panel Discussion on Test Cases
This paper is to briefly present the objectives and approaches of the Panel Discussion on test cases to be developed for 3d free surface flow model verifications, so that professionals...

Laplace Valve Stroking for Complex Piping Systems
LaPlace valve stroking to control water hammer is applied in complex piping systems with friction and without friction. Two types of system are analyzed. The law of operation of the valves...

A Physically-Based Model of Channel Widening
The application of many existing models of river channel morphology is limited by their inability to account for bank erosion and changing channel width through time. This paper outlines...

Theoretically-Derived Regime River Width
The governing equations describing the motion of fluid and non-cohesive sediment particles in alluvial channels are combined to analytically determine the equilibrium surface width of...

 

 

 

 

Return to search