Rational Design of Beam-Columns in Steel
The paper discusses the procedure as currently recommended in the AISC Manual for selection of beam-columns in steel and points to the inadequacy of this procedure for quick convergence...
Connection Flexibility and Steel Frames
The papers included in this book introduce and present methodologies for the analysis and design of frames which take into account the effect of joint flexibility on the response characteristics...
Rehabilitation, Renovation, and Reconstruction of Buildings
This document constitutes the proceedings for a National Science Foundation funded workshop to discuss research needs pertaining to the buildings side of infrastructure. It includes discussion...
Slashing Tunnel Costs
The second U.S. application of the New Austrian Tunneling Method at Washington D.C.'s Metro system is described. The innovative method has been used overseas, but American...
Tunneling a Bridge
Linking an addition to the Georgia World Congress Center in Atlanta required a pedestrian tunnel through a railroad embankment 100 ft wide and 40 ft high, with no disruption of train service...
Advances in Short Span Steel Bridges
Applying recent research to the design of short span steel bridges can lower their cost and maintenance. Such research involves improved limit state criteria, more uniform lateral load...
Jointless Bridge Decks
Deck joints in a bridge are the source of many problems over its lifetime. In time, chances are good the joint will leak, permitting water and salt to leak through. Often this leads to...
Tunnel Shotcreting�Strength in Fibers
Steel fiber reinforced shotcrete (SFRS) costs less, has a lower rate of rebound and allows modern excavating equipment to advance with fewer interruptions than conventional shotcrete....
Engineering for Steel Construction
Structural Steel Details: Comments on Divided Responsibility
Five readers responded to an article on responsibility for structural steel details published in
Reinforcing Roof Truss Frames Under Load
Without altering the roof structure of an industrial boiler plant, a long-span steel truss frame was modified in place to support heavier loads. The owners of an industrial boiler plant...
Steel Girder Bridge Sets Record Length
The Veterans Memorial Bridge at Ottawa, Ill., is the longest plate girder, stringer type bridge in the country with spans of 385, 510 and 305 ft. Value engineering played an important...
Building Failures�Construction Related Problems and Solutions
A leadership group of representatives from the fields of structural design, construction, building inspection, the law and insurance agreed that if five changes are made in the way building...
Seismic Risk and Decision Analysis of Lifeline Systems
This paper provides general guidelines for performing lifeline seismic risk and decision analyses. Relevant input models are introduced as they support the performance of component and...
Performance of Water and Sewer Lifelines in the May 2, 1983 Coalinga, California Earthquake
Water supply and filtration systems for the City of Coalinga suffered little damage. The water transmission system suffered five breaks. The urban distribution system was disrupted, but...
Dynamic Response Correlation of Cylindrical Tanks
The May 1983 Coalinga Earthquake provided an opportunity to correlate earthquake performance of cylindrical liquid storage tanks with behavior observed in laboratory shaking table experiments....
Bridge
Named Outstanding Civil Engineering Achievement of the Year, the Luling-Destrehan Bridge across the Mississippi River, twelve miles north of New Orleans, has a 1,222 ft. main span that...
Retaining Wall
The foundation of this off-ramp in Manchester, New Hampshire is made up of end-bearing piles and sloping rock anchors�an innovation that is unique to the United States. End bearing piles...
Bascule
The Columbus Drive Bascule Bridge in Chicago is one of the largest bascule bridges in the world with a 270 ft. span and 1l0 ft. width. Four welded steel box girders support each of the...
Computer-Aided Load Monitoring System for Nuclear Power Plant Steel Framing Structures
The design of nuclear power plant steel framing structures is a long and involved process. It is often complicated by numerous changes in design loads as a result of additions, deletions...
Return to search