Forces Acting on a Vortex-Excited Vibrating Cylinder in Planar Oscillatory Flow
An experimental investigation into the vortex-excited vibration of a circular cylinder in planar oscillatory flow has been made with emphasis being placed on the amplification of the forces...
Conceptual Evaluation of Dam Safety by Instrumentation
The criteria governing the design of dams can frequently be imprecise. One of the most practical methods of evaluating dam safety in the dam safety surveillance programs is to check the...
Use of Linear Programming for Hydraulics Problems
Water is becoming a more and more precious commodity worldwide with each passing day. At the same time, the optimum and most productive solutions to water control and utilization are becoming...
Pump Selection Program and a Better User Interface
Numerous highly innovative computer solutions to engineering problems are of little use to the practicing engineer because these programs are not supported by adequate user interface....
The Equivalence of Path and Node Methods for Water Distribution Network Analysis
This paper deals with the equivalence between commonly employed methods, path and node adjustment methods, for analyzing water distribution networks. The basic equations for steady-state...
Stabilization of an Alluvial Channel in an Urbanized Area
Grade stabilization structures have been used for many years to control degradation of alluvial stream in the southwest. These structures result in reducing the gradient of the stream...
Effects of Spillway Operation on Cavitation Damage to Hugh Keenleyside Dam Spillway
The Hugh Keenleyside Dam (also known as Arrow Dam) is located on the Columbia River, at the outlet of Lower Arrow Lake, 53 km north of the Canada - U.S.A. border. The project has been...
Minimizing Erosion Damage to Embankments, Spillways, and Channels With Articulated Concrete Block Revetment Systems
The results of a multi-year applied research and testing program, focusing on the hydraulic performance of various types of erosion control products and revetment systems in steep-slope...
Chute Design Using Concrete Building Blocks
Chutes constructed using concrete building blocks for erosion control on ephemeral streams have performed successfully. The chutes consist of a layer of blocks placed on a geotextile over...
CCM Overtopping Protection on Three Parkway Dams
Cellular concrete mat (CCM) overtopping protection systems have been designed for and will be installed on three small embankment dams along the Blue Ridge Parkway. Based on recent field...
Overtopping Protection for Embankment Dams
Modifications that allow safe overtopping during large flood events can be made to existing embankment dams. These modifications are on the leading edge of technology and require special...
A Tale of Two Laboratories
Two unusual research centers are built with the materials that will be studied in them, but the similarities end there. GE Plastics' $10 million Living Environments concept...
Advances in Pipeline Materials
Pipelines transport water, storm run-off, process wastes, petroleum, natural gas, slurries, solids, sewage, steam and other fluids either by gravity or under pressure. Pipelines are also...
Selection of Hole Size for Fluidization Pipes
Two-dimensional fluidization experiments are performed on fine and medium coarse quartz sands at depths of 25.4 and 42 cm. Four supply pipes are used with orifice diameters of 1.587 mm...
OTEC Sea Water Systems Technology Status
A workshop was conducted in April 1988 to provide an expert critique of the fabrication and deployment options for the seawater systems (all piping required to draw the seawater) of land-based...
OTEC Seawater Pipe Cost Comparisons
Describes a material which can substantially reduce the cost of seawater pipes and two methods for building and deploying such pipes for use in land-based OTEC installations, outfall sewers,...
U.S. Construction Aggregates
Crushed stone and sand and gravel are the two main sources of natural construction aggregates in the United States as well as in the world. At the beginning of the 20th century, the production...
Large Stone Mixes Make a Comeback
Large stone hot mix asphalt common at the turn of the century, is making a comeback in popularity in hot mix asphalt design. Large stone hot asphalt mixtures are being used as a way to...
Bond Strength of Epoxy-Coated Reinforcement to Concrete?An Update
The results of a large-scale study to determine the effect of epoxy coating on bond strength is described. The study addresses the effects of coating thickness, deformation pattern, bar...
Influence of Epoxy Coating on Stress Transfer from Steel to Concrete
To assess the influence of epoxy coating on the bond characteristics of reinforcing bars, a series of tests was conducted to determine differences in stress transfer between coated and...
Return to search