Double Angle Bracing Members
It has been pointed out that when a single line of bracing is used, the member is usually made from structural tubing. It has been suggested that when the loads are not too great, consideration...
Buckling Load of Tapered Columns
The basic tapered column with larger section in the center, is considered using Rayleigh-Timoshenko method. Column has linearly increasing Io with...
Cold-Formed Z-Sections Under Axial Load and Bending
The use of cold-formed Z-section members as beam-columns presents some unique design problems which are not adequately addressed in the current design specifications. If these members...
Strength of Biaxially Crooked Jumbo Columns
The ultimate strength of axially loaded jumbo columns with biaxial initial out-of-straightnesses is analyzed by the finite element method. The analysis makes use of the measured residual...
A Comparison of Performances of Various Frictional Base Isolation Systems
The results of a comparative study of the performances of several frictional base isolation devices including the Sliding-Joint, the French System, and the Resilient-Friction isolators...
Frequency Response Design of Controlled Structures
The installation of optimal control systems has been shown to be effective in reducing the vibration responses of structures. In addition to the effectiveness, there are many factors that...
Applications of Fuzzy Mathematical Programming in Structural Optimization
In this paper, several applications of fuzzy mathematical programming in structural optimization are reviewed and discussed. In addition, a formulation of optimum earthquake resistant...
A KBES for Seismic Design of Buildings
A knowledge-based expert system for earthquake resistant design of buildings is described. The knowledge-intensive nature of the domain and the consequent motivation for an expert-system...
A Knowledge-Based System for Evaluating the Seismic Resistance of Existing Buildings
The large number of existing buildings designed without considerations of seismic loading warrants the development of computer aids for the evaluation of their seismic resistance. Since...
Some Interactive Graphics and Parallel Processing for Earthquake Engineering
Ongoing research at Cornell University on computer-aided earthquake engineering of building structures is exploiting innovations in computing in several areas. Although some of the approaches...
Optimization for Exact Stability of 2-Bar Trusses
This paper is concerned with the structural optimization problem of minimizing the weight of a 2-bar truss subject to nonlinear stability constraints. Optimization problems for stability...
Microsilica (Silica Fume) Concrete Durability in Severe Environments
Microsilica (silica fume) concrete has provided increased durability in a variety of aggressive environments. Technical information is presented for microsilica concretes exposed to fire,...
Wood Diaphragms: Performance Requirements and Analytical Modeling
Wood diaphragms represent the principal mechanisms for resisting lateral loads in many light-frame buildings. While recent research has provided several mathematical models for predicting...
Forces in Unbonded Tendons
A rational analysis procedure for the calculation of tendon forces in prestressed beams with unbonded tendons is discussed. The prestressing tendon is analyzed as a tight-string which...
LRFD for U. S. Bridge Design ? Validation Issues
During the 1987 meeting of the AASHTO Subcommittee on Bridges and Structures, recommendations from the National Cooperative Highway Research Program (NCHRP), Project 20-7/31, regarding...
Strength Evaluation of Existing Reinforced Concrete Structures
The load test as described in ACI 318-83 Chapter 20, entitled 'Strength Evaluation of Existing Structures,' was conducted at 60%, 80%, and 100% of the calculated...
Wind Performance of Asphalt Roofing Shingles
Pre-seal and post-seal wind resistance of asphalt roofing shingles is discussed. A test method for evaluating pre-seal wind damage is described. Wind tunnel testing results are presented...
A New Proposal of Design Wind Loads for Beams Supporting Long-Span Roofs
The wind tunnel testings of wind pressures acting on long-span roofs are carried out. Dynamic wind pressures are measured simultaneously at a lot of points on the roofs. The instantaneous...
Toward an LRFD-Based AASHTO Bridge Specification
During the 1987 AASHTO Bridge Committee Meeting, recommendations from NCHRP Project 20-7/31 regarding the development of a probability-based LRFD bridge specification were accepted. NCHRP...
Evaluation of Bridge Safety and Remaining Life
In developed countries, the emphasis on the infrastructure is changing from new construction to the safe maintenance of existing structures. Highway bridges represent an excellent example...
Return to search