ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Dynamic Analysis of Sliding Seismic Isolators
The friction pendulum system (FPS) sliding seismic isolators are being used for the seismic isolation rehabilitation of the U.S. Court of Appeals Building, San Fransisco. This paper will...

Dynamic Response of an Infinite Beam Supported by a Fluid
The objective of this study is to investigate the dynamic response of an infinite beam supported by a fluid on one side, and subjected to dynamic loading on the other side. The fluid underneath...

Two-Dimensional Statistical Micromechanical Models for Microcracked Brittle Solids
Recent development undertaken by the authors in two-dimensional statistical micromechanical models for brittle solids with randomly located interacting microcracks is presented. Overall...

Determination of In-Situ Stresses From Acoustic Emissions
Acoustic emissions (AE) are microseismic activities that are generated in concrete by cracking and damage. The rate of Acoustic Emissions, called the 'Event Rate', can provide indication...

Evaluating Polymer Concrete Bridge Expansion Joints Using Acoustic Emission
This study is to simulate the acoustic emission (A/E) of polymer concrete bridge expansion joints subjected to controlled representative loads by a rotating test apparatus on a circular...

Modal Coupling Effect of Non-Classically Damping
The equations of motion of a structure in undamped modal coordinates may have non-zero off-diagonal terms in the damping matrix. Although these terms are commonly neglected, studies have...

Nonlinear Dynamic Response of Framed Structures Using the Mode Superposition Method
This paper describes a methodology for nonlinear dynamic response analysis of framed structures using the mode superposition method. A portal frame example is presented and compared to...

Nonlinear Analysis of Strain-Softening Damage under Monotonic and Cyclic Loading
The paper reviews the modeling of damage by the microplane model and presents extensions required for cyclic loading. The general microplane constitutive model is implemented in a three-dimensional...

Automated Identification of Compression-Induced Cracking in Cement Paste
The development of image analysis techniques to identify cracks using scanning electron microscope images of hydrated cement paste is described. Cracks are identified based on both the...

Dugdale Model Applied to Crack Interactions
It is doubtful that modelling crack interactions problem within the context of elasticity adequately reflects the physical aspects as the failure of brittle material is approached. A model...

Contact Induced Damage
Contact induced damage is an important source of potential failure of engineering components. The particular applications where this damage occurs are in the automotive, aerospace and...

Sensitivity of Lifeline Response to Models for the Spatial Incoherence of the Seismic Ground Motions
The sensitivity of the response of above-ground and buried lifelines to different models describing the spatial variability of the seismic ground motions is examined. It is shown that...

First-Passage Failure Predictions for Yielding Primary-Secondary Systems
Approximate methods are used to investigate the effect of nonnormality (non-Gaussianity) on the time of first-passage failure for a linear secondary system mounted on a yielding primary...

First Order Importance Sampling Method and its Variance Reduction
This paper proposes an Importance Sampling method for structural system reliability problems with linearized modal failure surfaces. It has the advantage of locating all samples in the...

Flexible Plates for Control of Stress Distribution
Use of a flexible plate in minimization of soil reaction concentrations at the edge was analyzed. The analysis utilizes a solution for vertical vibrations of the circular flexible plate...

Evolution of Damage in Brazilian Test Using Holographic Interferometry
A common method for estimating the tensile strength of concrete is the Brazilian Test. The test is carried out by loading a cylinder on its side in diametral compression. Accodring to...

Random Initial Heterogeneity and Degradation in Brittle Materials
The question of implementation of the initial state of the material is addressed. The problem is tackled by assuming random initial values for a relevant variable, within a prespecified...

On the Role of Dispersive Waves in Strain-Softening Media
Wave propagation in strain-softening continua is investigated numerically and analytically. It is argued that localisation which typically acts as a precursor of failure, can only be described...

Retrospect and Prospect: Micromechanics
In the mechanics community the term micromechanics is often used to identify scientific efforts in which certain overall macroscopic material response and failure modes are characterized...

The Theory of Elasticity: 1950-1992 and Beyond: Concluding Remarks
Forty years ago the theory of elasticity could be completely characterized by A.E.H.Love in his monumental treatise as an effort to reduce to calculation the internal state of stress produced...

 

 

 

 

Return to search