Maximizing Utility of Interfaces for Hydrologic Models
From the time a watershed layout has been determined, there is sufficient information for a computer to generate a command sequence for hydrologic simulation. Recognizing this fact, an...
On the Choice Between Annual Flood Series and Peaks Over Threshold Series in Flood Frequency Analysis
Statistical techniques are often used to estimate extreme flood events for the design of a flood-control structure or for any other flood-related purpose. Two kinds of models are commonly...
Comparison of Hydrograph Simulation Techniques Used in Structural Design and Watershed Systems Modeling
This paper describes a basin study in which traditional unit hydrograph analysis methods were compared to the E. J. Inman hydrograph technique. Study results indicate that, where suitable...
Hydraulics of Enlarging Cannonsville Reservoir
This paper describes the hydraulic studies performed for enlarging the Cannonsville Reservoir with a gate system which could raise the normal storage level without having an adverse effect...
Overview--Committee Report on Dam Safety Guidelines
In November 1984 the Surface Water Hydrology Committee appointed a task committee with the assignment to suggest standards for the hydrologic safety design of dams. The committee report...
Criteria for Spillway Design Floods
The procedures outlined in this paper only address the hydrologic safety criteria for spillway design floods. The recommended procedures are based on a careful identification of the social,...
Indemnification Costs in the Dam Safety Decision
The ASCE Task Committee on Spillway Design Floods has proposed safety criteria for three categories of dams. Category 1 dams are those with anticipated failure consequences so large and...
Hydrologic Runoff Modeling of Small Watersheds: The Tinflow Model
TINFLOW is a PC-based Geographic Information System (GIS) that utilizes the Triangulated Irregular Network (TIN) and associated data structures, together with a deterministic, finite difference...
Utility Programs for DWOPER and DAMBRK
Time and computer resources greatly limit potential investigations and sensitivity anslyses. In order to facilitate modeling with the National Weather Service (NWS) programs DWOPER (Operational...
Safety Design Flood for Too Wide Creek Dam
This paper presents an example application of the procedure developed by the ASCE Task Committee on Spillway Design Floods for a dam on the Too Wide Creek. The example was developed from...
Analysis of Drought Indicators
The Pennsylvania Department of Environmental Resources currently monitors five parameters in its regional water supply management program. These are: (1) accumulated precipitation deficit;...
Criteria for Selecting a Reservoir Routing Method
Results of an investigation comparing dynamic and storage reservoir routing applied in dam safety analyses are presented. Outflow hydrographs computed by these reservoir routing methods...
Automatic Calibration of Conceptual Rainfall-Runoff Models
An automatic calibration strategy applied to land and channel components of the National Weather Service River Forecast System is outlined. Aspects discussed include the objective function...
A Modal Coupling Procedure for Structural Dynamics
A method is presented for synthesizing the real modes of substructures to obtain the complex modes of the combined structure. These complex modes properly include the nonclassical damping...
A Comparative Study of Different Base Isolators
A comparative study of the effectiveness of four different base isolators is carried out. The structure is modeled as a rigid mass and the accelerograms of the North-South component of...
Response of Structures to Horizontal-Vertical Earthquakes
In the present work, the responses of a class of hysteretically nonlinear structures subjected to the combined horizontal and vertical random ground accelerations are studied. A massless...
Reliability of a Frictional System with Uncertainty
In recent years, more emphasis has been placed on the study of random vibration of structures with uncertain parameters. Most of these have dealt with second order statistics of the response...
Seismic Response of Simple Structures with Coulomb Damping
A single story structure incorporating a floor-sliding mechanism for dissipation of vibration energy through Coulomb friction damping is examined. The response of this structure is evaluated...
Cracking of a Tilt-Up Structure Due to Dynamic Loads
The extensive cracking of a tilt-up reinforced concrete structure is discussed. The site investigation revealed horizontal cracks at two feet to seven feet above a mezzanine level which...
Dynamic Behavior of R/C Buildings in Vi? del Mar, Chile
The Chilean earthquake of 3 March 1985 resulted in an effective peak acceleration of 0. 36g in the coastal city of Vina del Mar. The city had an inventory of over 400 reinforced concrete...
Return to search