Conical Test Load Measuring Compressibility
(Originally published in
Asphalt Parking Lot Runoff Nutrient Characterization for Eight Sites in North Carolina, USA
The objectives of this study were to characterize asphalt parking lot runoff quality and determine factors influencing nutrient concentrations and loads. Event mean concentrations (EMCs)...
Non-Destructive Strength Evaluation of a Continuous, Reinforced Concrete Slab Bridge
In the state of New Mexico, a significant number of reinforced concrete slab (RCS) bridges provide service on interstate highways I-10, I-25, and I-40 that are subjected to large amounts...
Toward a Unified Approach to Anchorage in Reinforced Concrete Design
The introduction of rationalized design procedures for cast-in and post-installed anchors inEurope and the U.S. was intended to provide a uniform factor of safety for anchorages inconcrete,...
An Experimental Study on the Behaviour of Full-Scale Composite Steel Frames under Furnace Loading
In view of recent large fires in tall buildings, such as One Meridian Square (USA), East Tower Central Park (Venezuela), World Trade Center (USA) and Windsor Tower (Spain), there has been...
Some Case Histories of Pile Foundations in Permafrost
Foundations for permafrost conditions should conform to one of three basic design principles: keep it frozen, let it thaw, or thaw the ground before construction. To keep the permafrost...
Characterizing the Pathways and Characteristics of Nutrients Discharging from Ground-Water to Surface Water
Any investigation of surface-water quality for a lake or pond requires accurate estimates of the contributing contaminant or nutrient loads. In many cases, inflow from the adjacent ground...
Strong Diagonals
Exterior Diagonal Systems that carry both gravity and lateral loads in building structures � known as exodiagonals or diagrids � are increasingly being used worldwide to provide freedom...
Offshore Technology in Civil Engineering
Hall of Fame Papers from the Early Years
Prepared by the Subcommittee on Offshore Technology Conference Support of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...
Foundation Loading: Introduction
This chapter introduces the subject of foundation loading....
Foundation Loading
This chapter discusses the tabulation of foundation loading data in Microsoft Excel....
Load Resistance Factor Design
This chapter discusses the tabulation of load resistance factor design data in Microsoft Excel....
Two-Way Slab Loading
This chapter includes drawings pertaining to two-way slab loading....
LRFD Compared to Working Strength Loads: Introduction
This chapter introduces the subject of load resistance factor design as compared to working strength loads....
LRFD Compared to Working Strength Loads
This chapter contains examples used to demonstrate the design of footings to resist seismic loads....
Strength Design in Aluminum
A Review of Three Codes
Prepared by the Task Committee on Strength Design in Aluminum of the Committee on Special Structures of the Committee on Metals of the Structural Engineering Institute of ASCE. ...
Analysis of Dynamic Laterally Loaded Pile in Clay
Deflections of laterally loaded pile groups are strongly affected by the degree of pile head fixity. If the cap provides perfect restraint against rotation, deflections are only about...
Tying It All Together
The Rancocas Greek Bridge, a steel tied arch designed for both light-rail and freight train loading, may be the first bridge of its kind to carry freight trains in the United States....
Micropiles to the Rescue
When a Michigan energy concern began upgrading the equipment in one of its operating power plants, engineers were asked to find an economical and nondisruptive way to support the new loads...
Flexural Behavior of Slender Post-Tensioned Masonry Walls
The 2002 edition of the Masonry Standards Joint Committee (MSJC, 2002) design provisions for masonry structures includes a chapter on the design of post-tensioned masonry (PTM) walls with...
Return to search