The Extremes of Combinations of Environmental Loads
The objectives and the general approach of an offshore environmental data and extremal analysis are described. The intention is to develop long-term design values of wave, wind and current...
Statistical Analysis of Australian Ground Snow Loads
This paper is concerned with the statistical analysis of snow data from the alpine areas of southeastern Australia (above 1200 m). In these areas, the local variation is large and contour...
Probabilistic Approach to Stress Distributions for Orthotropic Wood Plates
Probabilistic approach to the stress distributions of an orthotropic wood plate is discussed. The stress distributions for the orthotropic elastic media are fully dependent of the material...
Application of Probabilistic Reliability Analysis Methods to Ariane 5 Unequipped Booster Case
The paper demonstrates the capabilities of probabilistic structure analysis methods as a tool to support the design and manufacture of the Ariane 5 Unequipped Booster Case within a RAMS...
Transportation Cask Life Cycle Cost Uncertainty Analysis
This paper demonstrates an uncertainty analysis methodology using random sampling. This methodology has been applied to a nuclear waste transportation code, and several transportation...
Development of a CRUD Particle Size Distribution and Its Effect on Cask Source Term and Containment Analyses
Spent pressurized-water reactor (PWR) and boiling-water reactor (BWR) fuel rods from three reactors were examined by hot cell periscope, energy dispersive x-ray analysis, and scanning...
Clearing Space Debris Using Energetic Materials
Space debris is growing at an alarming rate. It consists not only of old, unusable payloads but also aluminum oxide combustion products of various space delivery systems and small fragments...
Investigation of HVAC Systems in Low Gravity Application
This paper has been developed to identify and summarize the principal areas of investigation necessary to design and install functional HVAC systems in low gravity applications. These...
The Optimum Dimensions of Radiative Spines
Radiative pin fins (spines) are important in conjunction with heat rejection systems for space applications. In the design of radiators for space applications, spines possessing minimum...
Upgrading Hydraulic Infrastructure for Level One Redundancy
In the current paper a methodology is presented for upgrading any single source water distribution system in order to provide a level one system redundancy at a minimum cost. A level one...
Predicting Watermain Breakage Rates
Recent studies on water main breakage have shown significant spatial and temporal clustering in the breakage pattern. The methodology described in the paper provides the basis for a prediction...
Evaluation of Global Warming Impact on Soil Moisture and Water Runoff in Texas
In this paper a numerical evaluation of the variability of soil moisture and surface runoff due to global warming is carried out. An analytical model of the soil moisture balance based...
A 3D-Stereo Graphics Interface for Operational Great Lakes Forecasts
A system for real-time predictions of Great Lakes physics and transport characteristics is now being implemented. The full 3D nature of the predictions demands accurate, high speed computer...
Siting the New Boston Harbor Outfall: Near-Field Analysis
In the near-field analysis for Boston's proposed Deer Island outfall to Massachusetts Bay, multiple initial dilution calculations were applied to estimate the frequency distribution...
Comparison of Computed and Observed Velocities at Three Estuarine Sites
The Generalized, Longitudinal-Vertical Hydrodynamic and Transport model (GLVHT) has been applied to the Patuxent River estuary, the Raritan River Estuary and the Arthur Kill. The applications...
A Method for Estimating Peak Flows from Small Agricultural Watersheds
An attempt was made to develop a method for estimating peak runoff from agricultural watersheds by analyzing precipitation and runoff data, and incorporating the results into a procedure...
Water Erosion Prediction Project (WEPP) Watershed Model: Hydrologic and Erosion Calculations
The Water Erosion Prediction Project (WEPP) watershed model is a distributed continuous simulation model developed to compute the spatial and temporal distribution of erosion and deposition...
Morphology and Roughness in the Hydraulics of Large Bed Element Channels
The evolution of natural steep channels is a function of two factors in accordance with the principle of least action: flow distribution in the channel and terrain geomorphology. Large...
Precipitation Variability Effects on Modeled Soil Water Deficits
Effective management of forages in steep Appalachian pastures requires an understanding of hydrologic and microclimatic processes on the area. This study was conducted to determine the...
Rheological Properties of Simulated Debris Flows in the Laboratory Environment
Steady debris flows with or without a snout are simulated in a 'conveyor-belt' flume using dry glass spheres of a uniform size, 5 or 14 mm in diameter, and their...
Return to search