Riprap Incipient Motion and Shields' Parameter
Unobstructed incipient motion data from a variety of sources are compiled to re-examine current thinking regarding riprap stability. Shields' framework is investigated and relationships...
A Comparison Between Two Kinematic Wave Solutions for Movement of Debris Flows
We compare an asymptotic kinematic wave solution for movement of debris flows with a solution obtained by the method of characteristics. The differences between the two solutions in the...
Roll Waves in Mud Flow
Permanent roll waves on a shallow layer of fluid mud which is modeled as a power-law fluid is studied. Based on long-wave approximation, momentum integral method is applied to derive the...
Turbulent Velocity Flutuations in Natural Rivers
The longitudinal and transverse components of flow velocity, as well as the normal and tangential stresses, must be expected to fluctuate with time and space when flow at a high Reynolds...
Prediction of Occurrence and Runoff Analysis of Debris Flow
A debris flow will occur on a slope when the rainfall exceeds a certain value determined by the hydraulic, geological and topographic properties of the slope. To estimate this critical...
Large-Scale Embankment Overtopping Protection Tests
The U.S. Bureau of Reclamation (Reclamation), Colorado State University (CSU), and the Electric Power Research Institute (EPRI) have an ongoing cooperative research effort to determine...
Progressive Failure of an Overtopped Embankment
The failure of an overtopped embankment is a problem of a very complicated nature. Concerned organizations are interested in information that can be used in future planning and development...
Oxygenation Experiments in the Wave Breaking Zone
Experiments on oxygenation due to waves breaking on a uniformly sloping beach were carried out at the laboratory of Harbor Works, National Technical University of Athens. The influence...
A Finite-Difference Model for 3-D Flow in Bays and Estuaries
This paper describes a semi-implicit finite-difference model for the numerical solution of three-dimensional flow in bays and estuaries. The model treats the gravity wave and vertical...
The Courant Number and Unsteady Flow Computation
The Courant number C, the key to unsteady flow computation, is a ratio of physical wave velocity, ?, to computational signal-transmission velocity, ?, i.e., C = ?/?. In this way, it uniquely...
Three-Dimensional Modeling of Tides and Wind-Waves
A third-generation coupled discrete numerical wave prediction model is dynamically linked to a three-dimensional hydrodynamic model. The effects of water level, currents, and bottom friction...
New Canadian Provisions Related to the Design of Composite Beams
In this paper, the new provisions in CAN/CSA-S16.1-M89 for the design of composite beams, together with reasons for changes, are discussed. Some of the new provisions reflect results of...
Shear Connection in Composite Beams
This paper considers the influence of the shape of the deck profile on the shear connection of composite beams. It was found that the existing strength reduction factor can be unconservative...
Modern Design Concept for Composite Slabs with Ductile Behaviour
Numerous tests with different types of composite slabs have been carried out in the laboratory for constructional engineering of the University of Kaiserslautern, Germany in order to determine...
Design of Shear Connectors in Composite Bridge Beams
A new approach is described for the design of stud shear connectors, in composite steel and concrete beams that are subjected to vehicular loads, which allows for the interaction between...
Design of Composite Slabs for Vertical Shear
Three major modes of failure should be considered in the design of the positive moment regions of composite slabs incorporating profiled steel sheeting, viz.: flexure, longitudinal slip...
Composite Columns Subjected to Bending and Shear
This paper describes experimental as well as analytical studies of the post elastic deformation and fracture behaviors of wide flange steel encased reinforced concrete (SRC) composite...
Steel Beams with Reinforced Concrete Stiffened Ends
For the construction of office building with long span beams, steel beams with reinforced concrete stiffened ends are being used in order to increase the stiffness. This paper describes...
Behavior of Concrete-Filled Steel Tubular Three-Dimensional Subassemblages
Three-dimensional subassemblages consisting of a concrete-filled steel tubular column and four H-shaped beams were tested under a constant axial load on the column, constant beam loads...
Composite Beams with Headed Studs in Narrow Ribbed Metal Deck
This paper presents the results of sixteen push-out tests conducted to study the behavior of headed stud connectors in composite beams with narrow ribbed metal deck placed parallel to...
Return to search