Drag Characteristics of Coarse Sediment in Clay Suspensions
Drag characteristics of spherical particles in clay suspensions, such as coarse sediment in hyperconcentrated flows, has been analyzed by using a limited data available in the literature....
Hydraulic Modeling of Fish Screens
Hydraulic model studies coupled with available knowledge of fish behavior can be important component in the development of fish-screening systems. To reproduce in a model the flow field...
Rheometry of Natural Sediment Slurries
Recent experimental analyses of natural sediment slurries yield diverse results yet exhibit broad commonality of rheological responses under a range of conditions and shear rates. Results...
Hydraulic Model Studies of Y-Branch
Hydraulic model studies were made for the Y-branch steel penstock located in a vertical bend. The model tests were performed for various modes of pumping and generating operation. The...
Estimating Bridge Scour in New York from Historical U.S. Geological Survey Streamflow Measurements
Historical streamflow measurements by the U.S. Geological Survey an bridge-inspection reports by the New York State Department of Transportation are being used to estimate scour at 31...
Relation of Local Scour to Hydraulic Properties at Selected Bridges in New York
Hydraulic properties, bridge geometry, and basin characteristics at 31 bridges in New York are being investigated to identify factors that affect local scour. Streambed elevations measured...
Scour Inspection Using Ground Penetrating Radar
This paper examines the capabilities of Ground Penetrating Radar (GPR) for river bed scour inspection based on a study carried out by Clarkson University, Potsdam, New York in association...
Time-Dependent Landslide Probability Mapping
Case studies where time of failure is known for rainfall-triggered debris flows can be used to estimate the parameters of a hazard model in which the probability of failure is a function...
Evaluation of Hydraulic Structure Reliability Considering Uncertainties in Hydrologic Models
Uncertainties in a hydrologic model give rise to uncertainty in model outputs which, in turn, can be used for reliability-based design and /or evaluation of hydraulic structures. This...
Serviceability Stress Limits for Composite Beams
Serviceability limits are increasingly becoming the critical design requirement for composite beams. A set of three illustrative design studies indicates that this is particularly true...
Thermal Shielding in Continuous Span Composite Slabs
The increasing popularity in Europe of composite slabs with cold-formed steel decking has underscored the need to improve calculation rules for the fire resistance. Existing rules have...
A Simple Finnish Method for the Structural Fire Design of Composite Structures
The structural fire design of composite structures in Finland has previously been based on furnace tests, which are expensive and take too much time to arrange. With the increasing prominence...
Chemical Resistance of Thermosetting Resins Used for Cured-in-Place Pipe
This paper summarizes the chemistry, short term physical properties, and long term chemical resistance for representative epoxy vinyl ester, epoxy, and polyester resins that are currently...
Equipment Systems for the Commercial Production of Modified Asphalt
A considerable amount of research has been centered on various asphalt modifiers and their effect on rheological properties. As the paving industry is now focusing on high performance...
Application Cases of Slurry Seal in Japan
In Japan, slurry seal began to be used for repairing asphalt pavements at around 1963, mostly for repairs of prefectural and municipal roads. In recent years, however, it has rarely been...
SHRP Deformation Test?Asphalt Mix Tests and Analysis Systems
From analyses of existing information on the permanent-deformation characteristics of asphalt/binder-aggregate mixes, as well as the development of permanent deformation in pavement structures,...
Liquefaction Potential of Western Puerto Rico
The historical seismic record, paleoseismic evidence, high population density, time expired since the last major earthquake, and the presence of liquefiable sands and soft clays combine...
The Proof is in the Pavement
A technique known as statistical quality assurance (SQA) lets DOTs quantify pavement quality by setting statistical guidelines for the work they will accept. SQA is a distinct departure...
Properties of Bottom Ash-Based Composite
High-calcium bottom ash, a by-product of the electric power industry, was evaluated for feasibility of use as a fine aggregate in structural grade concrete. Both fresh and hardened properties...
Digital-Image-Based Computer Modelling of Cement-Based Materials
Understanding the relationships among materials, processing, microstructure, and properties is critical in improving material design. This paper outlines an approach for furthering this...
Return to search