A Removable Submarine Cover for Drydock No. 2 Modernization
In order to provide balanced overhaul capability and flexibility in the 1990's and beyond, the Portsmouth Naval Shipyard in Kittery Maine, a major U.S. Navy submarine and overhaul repair...

Barbers Point Harbor: A Unique Solution for Port Upgrade
A remote-controlled model of a C9 containership was used to evaluate the navigability of existing harbor and entrance channel conditions in a three-dimensional physical model of Barbers...

A Storm Water Utility Case Study, Salt Lake City, Utah
In response to financial pressure on the City's general fund and the EPA's storm water regulations, Salt Lake City went through the process of developing and implementing a storm water...

Experimental Investigation of Self-Tapping Fasteners for Attachment of Corrugated Cladding Panels to Pultruded Fiber-Reinforced Plastics Beams in Industrial Building Construction
This paper describes an experimental investigation of self-tapping fasteners for the attachment of corrugated fiber-reinforced plastics (FRP) cladding panels to pultruded FRP beams. Although...

The Crown and the Curtain Wall
Crowning the complex curtainwall of an 870 ft concrete tower with a 150 ft high crown of aluminum masts in concentric rings above the 60th floor required ingenuity and extraordinary cooperation...

The Desalination Situation
Rapid growth is putting increasing pressure on water supplies in coastal communities. Conservation can only do so much, and providing new freshwater supplies is getting more expensive...

Specifying the Offshore Environment
Hindcasting has become a generally accepted method of producing long time series of environmental events from which environmental design criteria can be developed. The need for reliable...

Spectral and Statistical Characteristics of Wind Waves Off Canary Islands
Wave climate around Canary Islands is studied by means of statistical and spectral techniques. Maximum Entropy Method is used for obtaining the spectral density function. Autocorrelation...

Corrosion Fatigue of Deepwater Offshore Materials
Evaluation of the fatigue life of offshore structures operating in depths of up to 10,000 feet (3,048 m) requires knowledge of the combined effect of axial and hydrostatic loading on the...

Response Statistics of Tension Leg Platforms Under Wind Loads
This paper presents the direct integration method and Kac-Siegert technique to solve the first four cumulants in the general quadratic systems, and proposes the splitting technique to...

A Fourier Series Solution to Bottom Roughness Induced Stresses During Pipe Laying
Often during installation, a subsea pipeline must be laid along seabed portions with rough profiles. The pipeline is forced by the bottom irregularities to bridge across consecutive protuberances....

Pressure Pipeline Design for Water and Wastewater
This committee report, Pressure Pipeline Design for Water and Wastewater, is a revision of the 1975 ASCE publication Pipeline...

Safety Factors, Loads, and Impact
The loads given in this chapter are intended for general guidance only (including wind, ice, stream flow, etc.). Maximum deflections and rotations may likewise vary with national codes....

Dynamic Wind Loads
This chapter is concerned with the motions of cable stayed bridges that arise as a result of wind action. The aerodynamic phenomena that must be considered are vortex shedding, torsional...

A Laboratory Study of Shock Waves in Frozen Soil
This work has focused on two aspects of dynamic behavior of frozen soil: first, on the shock pressure attenuation, and second, on the shock Hugoniot. The use of long bars of frozen soil...

Analysis of Waterbody Surface Heat Exchange
The Edinger-Duttweiler-Geyer (EDG) approach for estimating heat exchange at a water surface was examined and its applicability to ice-covered waterbodies determined. The EDG linearized...

Effective Pressures Measured During Indentation Tests in Freshwater Ice
Indentation tests were conducted by pushing flat, vertical indentors of two different widths (50 and 100 mm) against the edges of floating, freshwater ice at different velocities (0.6-150...

Wind Tunnel Modeling of Time-Dependent Drift Topography
The aeolian wind tunnel is a useful tool for investigating not only the saltation physics of wind-driven sand, soil or snow, but also for determining the time-dependent development of...

Drifted Snow on Roofs
Drift snow loads on multilevel roofs account for about 75 percent of all snow load related roof collapses. A case history of snow drifts provides the foundation for a discussion of the...

Snow Transport as a Function of Wind Speed and Height
When limitations are placed on mass flux in the saltation layer, a regression equation relating mass flux to wind speed and height above surface, developed by Mellor and Fellers (1986),...

 

 

 

 

Return to search