Overfall Stress and Pressure Distributions
The magnitude and distribution of hydraulic shear stress and pressure on the boundary of a straight drop overfall are presented for multiple overfall heights and flow rates. Hydraulic...
Energy Dissipation Structure for Fixed-Cone Valves
Results of a model study to investigate the hydraulic performance of a proposed energy dissipation structure for fixed-cone valves are presented. Procedures for estimating pressures and...
Uplift Pressure below Gravity Dams on Rock
The magnitude of the uplift force at the base of a concrete gravity dam founded on rock is strongly dependent on the properties of the discontinuities within the rock mass. This paper...
Moose River Air Chamber Design and Performance
The Moose River Hydroelectric Project is a 12.5 MW development located in upstate New York. It employs an underground air chamber to protect the unit and power tunnel from pressure surges...
Computerized Measurement of Turbine Flow and Performance, Including Penstock Protection
The application of computer technology now makes it possible to measure turbine flows accurately, reliably and economically. The measurement is based on the differential pressure produced...
Oil Hydraulic Design for Turbine Control
The paper addresses three areas of Oil Hydraulic Design for Francis and Kaplan Turbines: smart accumulator condition sensors, high flow servo logic, and high pressures Wicket Gate cylinder...
Hydro Turbine Submergence
The elevation of a hydro-electric turbine above or below tailwater is based on hydraulic model studies to determine the critical sigma, defined as the ratio of barometric pressure plus...
Turbine Efficiency Measurements by the Pressure-Time and the Current-Meter Method at Paugan
Paugan generating station was built in the 1920s. Although the generators were converted from 25 Hz to 60 Hz in the mid 1950s, the original runners were in place until recently when a...
Transient Analysis of the Finchaa Hydroelectric Project
An iterative computer simulation procedure called LIQT (Liquid Transient), which performs simulations of hydraulic transients in closed conduit hydro-power systems, is used to estimate...
Fluctuating Pressure Measurements on a Large Hydro Turbine
The New York Power Authority is investigating the feasibility of upgrading the thirteen 150,000 kW turbines-generators at the Robert Moses Niagara Power Station to improve efficiency and...
New Roof for an Aging Temporary
The wartime temporary design of a 1942 industrial building justified use of green timber for its roof trusses and higher than usual allowable design stresses. Some 45 years later, a new...
Beam-Supported Slabs Subject to Edge Loading
A model is presented which allows a designer to estimate stiffnesses required to provide a given critical buckling load in beam-supported slabs subjected to biaxial edge loading, such...
High Pressure Grouting of the Bath County Tunnel System
A major grouting program was completed at the Bath County Pumped Storage Project between March and September 1985. High pressure grouting for seepage reduction was completed in a total...
Fretting Corrosion on Large Split Thrust Bearing Runners
In the early fifties interfacial slip was measured on laboratory models. Design improvements, resulting from these tests, were incorporated into later machines. These improvements appreciably...
Our Municipal Water System Has Power
Hydroelectric potential exists in the Boulder, Colorado municipal water system. Excess pressure is developed in the water system because the water originates in the Rocky Mountains, west...
Controlled Yielding of the Lateral Boundaries of Soil Retaining Structures
Lateral expansion of conventional or reinforced soil backfills is necessary to establish and maintain the minimum lateral stresses on soil retaining structures. Laboratory studies are...
Frequency Domain Site Response with Pore Pressure
A frequency domain analysis for seismic site response and liquefaction potential is developed. The analysis is based upon a nonstationary random vibration theory. The model uses an effective...
A Stochastic Model for Low-Cycle Elastic-Plastic Fatigue Crack Growth
In this paper a stochastic process approach is considered to represent the random nature of the low-cycle (elastic-plastic) fatigue crack growth process. A semi-Markov renewal model is...
Pore Pressure Development: Probability Analysis
The development and subsequent dissipation of excess pore pressure, p in a soil deposit subject to an external load is examined using probability concepts that account for uncertainties...
Time Series Analysis of Wind Pressures on Low Buildings
A new methodology for the description of local wind pressures on the building envelope of mono-sloped roof buildings by using time series analysis is described. A simple AR(1) model has...
Return to search