ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Bugs and Carbon Make a PACT
At its Chambers Works in southern New Jersey, DuPont was ordered to sharply reduce the BOD load in the wastewater it discharged to the Delaware River. Out of this mandate came the PACT...

Terzaghi Lectures
1974-1982
Sponsored by the Executive Committee of the Geotechnical Engineering Division of ASCE. This Geotechnical Special Publication contains eight lectures...

Physics-Based Modeling of Lakes, Reservoirs, and Impoundments
This book provides an overview of considerations that apply to modeling flow and transport in lakes, reservoirs, and impoundments using equations based on conservation principles. Specific...

Use of In Situ Tests for Foundation Design on Clay
Years of evaluated experience with the field vane test in soft clays have resulted in empirical correction factors well suited for design practice. An extension of L. Bjerrum's...

Deformation Characteristics of Cohesionless Soils from In Situ Tests
This paper is a summary of seven years experience gained by the National Electricity Board of Italy (ENEL), ISMES and Technological University of Turin in assessing these parameters using...

Seismic Cone Penetration Test
A new test, called the seismic cone penetration test (SCPT) is described. A small rugged velocity seismometer has been incorporated into an electronic cone penetrometer. The combination...

In Situ Testing for Lock and Dam 26 Cellular Cofferdam
The in situ testing consisted of split spoon and cone penetration tests, Menard and self-boring pressuremeter tests, and Marchetti dilatometer tests. The testing program proved to be challenging...

Pressuremeter Correlations for Preconsolidated Clay
Conventional triaxial compression and consolidation tests are often utilized to obtain parameters for design of foundations. More recently, Menard pressuremeter test results have been...

Ground Improvement Evaluation by In-Situ Tests
The application of in-situ testing to the design and evaluation of a large sand densification project for the Jebba Hydroelectric Development is described. Correlation between the standard...

Reliability of Pile Capacity Assessment by CPT in Overconsolidated Clay
Correlations for unit skin friction and end bearing are established between cone penetration test (CPT) records, triaxial data and a small data base of measured skin friction and end bearing...

Permeability, and the Field Pumping Test
Methods of estimating in situ permeability of soils are discussed including laboratory tests, borehole tests and field pumping tests, with emphasis on the latter. Techniques for designing...

Use of SPT and CPT Tests for Evaluating the Liquefaction Resistance of Sands
A cone penetration test (CPT)-liquefaction resistance relationship has been established using the large body of standard penetration test (SPT) data. Factors for relating CPT tip resistance...

In Situ Testing for Ground Modification Techniques
Presented are the status of three in situ testing techniques in relation to Ground Modification and a general overview of eight Ground Modification methods with case histories and appropriate...

Electrical In Situ Measurements for Predicting Behavior of Soils
A new method is presented for predicting the in situ stress-strain behavior of fine grained soils based upon in situ measurements of its electrical properties. The method involves the...

Comparison of the SPT,CPT, SV and Electrical Methods of Evaluating Earthquake Induced Liquefaction Susceptibility in Ying Kou City During the Haicheng Earthquake
The capability of SPT, CPT, Shear Wave Velocity and Electrical methods to evaluate earthquake induced liquefaction susceptibility of soil deposits consisting of sensitive clayey silts...

Flat Dilatometer Tests in Calibration Chambers
This paper presents the results of a series of Flat Marchetti's Dilatometer Tests (DMT's) performed in a large Calibration Chamber (CC) on dry Ticino (TS) and...

Residual Soil Settlement From Pressuremeter Moduli
The Menard pressuremeter test is briefly described, and practical drilling techniques are summarized for Piedmont residual soils. Applications and limitations of the pressuremeter are...

Landslide Investigations Using the Weight Penetrometer
The weight penetrometer is a light weight device and can be easily deployed on slopes not accessible to conventional exploratory tools such as drill rigs or cone penetrometers. The weight...

Liquefaction Study of Coal Refuse by Nuclear Gauges
This paper presents a technique for utilizing nuclear gauges to determine density and moisture content continuously throughout refuse embankments and slurry reservoirs. The nuclear measurements...

ECPT Investigation of a Slurry Trench Cutoff Wall
ECPT (electronic cone penetration testing) was used to investigate a soil-bentonite backfilled slurry trench cutoff wall at Calamus Dam in Nebraska, The wall was tested shortly after its...

 

 

 

 

Return to search