The Use and Performance of Seepage Reduction Measures
The utilization and performance of various foundation seepage reduction measures from over 100 dams situated on pervious soils throughout the world has been reviewed. Summary discussions...
Designing and Monitoring for Seepage at Calamus Dam
Given the complex, pervious nature of the foundation for Calamus Dam, every effort has been made to incorporate design features that will reduce and control the anticipated large volumes...
Use of Asphalt in Treatment of Dam Foundation Leakage, Stewartsville Dam
This paper presents the recent development and application of a hot asphalt grouting technique used to stop a 5,000 Imperial Gallons Per Minute (IGPM) (22,000 lpm) dam leakage under full...
Computer Applications in Grouting
The first use of computers during foundation grouting was tried by the Bureau of Reclamation on Ridgeway Dam in Colorado. It was very useful in monitoring real time down hole conditions...
Computer-Assisted Grouting Evaluation Systems
Electronic monitoring of cement pressure grouting at Ridgway Dam provides a powerful tool for geologic assessment of drilling and grouting results. Graphic surveillance and analysis of...
Grout Slurries?Thick or Thin?
In this paper some recent experiences in dam grouting in several countries are discussed where bentonite or Intraplast additives were used to control sedimentation, viscosity, grout density,...
Application of a Three-Dimensional Coupled Finite Element?Boundary Element Method
Three-dimensional conditions in underground construction occur at the face of a tunnel, at intersections of underground openings and around roughly equidimensional openings. As long as...
Prediction of Highway Construction Noise Levels
A model for the prediction of noise levels from highway construction operations has been developed under sponsorship of the Federal Highway Administration (FHWA). Noise sources are geometrically...
Noise and Air Blast from Construction Blasting
Noise generated by construction blasting differs from other construction noise because of its frequency content. The audible high frequency portion is accompanied by a non audible, lower...
Cost Assessment of Construction Noise Control
The results of a series of studies have provided noise control engineers with a method to estimate off-site construction noise levels and the cost of reducing these to acceptable levels....
Noise Assessment, Measurement, and Mitigation, an OSHA View
A discussion is presented on the Occupational Safety and Health Administration (OSHA) 29 CFR 1910. 95 General Industry noise exposure standards and the 29 CFR 1926. 52 and 1926. 101 Construction...
A Tale of Six Cities
Battle Creek is a four mile urban stream that had an erosion problem that was accelerating with urbanization of its watershed. Erosion created unstable ravine slopes over 60 feet high,...
Proposed Design Criteria for Composite Steel Deck Slabs
Composite steel deck slabs have continued to gain popularity; today they are one of the predominant means of floor slab construction in most typical buildings. The term 'composite...
Composite Bridge Design in Germany
A span length between 40 m and 12 m has been regarded as optimal up to the mid-60's for a composite design to compete with prestressed concrete or steel alternatives. With...
Dynamic-Fatigue Response of Continuous Composite Bridges
The dynamic response of continuous composite bridges and the influence of fatigue loading at resonance frequency on the structural response are investigated. It is shown that cracking...
A History of Adhesive Bonded Composite Members
The history and development of adhesive bonding in composite members is traced. Two forms of composite members are explained. Research from different parts of the world is compared. Applications...
Mixed Systems: Past Practices, Recent Experience, and Future Direction
A comparison is made between composite column capacities derived from the authors procedure utilizing the ACI (America Concrete Institute) code requirements, and previously published semi-empirical...
Recent Developments in Mixed Steel-Concrete Systems
Mixed steel-concrete systems have emerged into a well established new system that can be used as readily as either steel or concrete systems for high-rise buildings. Mixed systems offer...
Bond Stress of Embedded Steel Shapes in Concrete
This paper describes an investigation into the bond stress developed between steel shapes and reinforced concrete when the concrete is lightly stressed. A brief discussion of previous...
Recent Developments for Composite Buildings in Japan
Research work and construction practice of composite steel and reinforced concrete structural systems in Japan are reviewed, based on the data gathered by the working group of the Architectural...
Return to search