Size Effects in the Fracture of Quasi-Brittle Materials
Causes and influences of the structural size effect that is exhibited by materials such as concrete, mortar, ice rock and ceramics, are discussed. The size effect law, which models this...
Laboratory Observations of Macroscopic Failure Modes in Freshwater Ice
A review is presented of tests performed in the laboratory by several investigators on indentation in freshwater ice. A number of the observed failure modes are discussed. From the results,...
Some Questions on Fracture Mechanics of Ice and Ice Covers
Investigation of natural processes of deformation and fracture of ice covers, and processes of its interaction with icebreaker or ice-resistant structures requires as a rule considerations...
Effective Pressures Measured During Indentation Tests in Freshwater Ice
Indentation tests were conducted by pushing flat, vertical indentors of two different widths (50 and 100 mm) against the edges of floating, freshwater ice at different velocities (0.6-150...
Loads and Vibration Induced by Compressive Failure of Ice
In earlier work, attention was focussed on the narrow length of crushed ice adjacent to the structure, which was seen as the seat of vibration associated with ice crushing. Crushed ice...
Application of Ice/Structure Interaction Concepts to a Real Time Ice Risk Assessment Computer Model
The successful and safe operation of an Arctic offshore exploration structure greatly depends on the implementation of alerts procedures. In order to assess alerts levels, a computer model...
Wang's Equation for Ice Forces From a Pressure Ridge
Yung-shih (Tony) Wang has presented an equation for the breaking loads from a multiyear pressure ridge on a conical structure. The three distances that define the position of the plastic...
Drifted Snow on Roofs
Drift snow loads on multilevel roofs account for about 75 percent of all snow load related roof collapses. A case history of snow drifts provides the foundation for a discussion of the...
Snow Fence Operational and Material Testing
The proliferation of snow fence products since the late 1970's presents an opportunity for optimizing the control of drifting snow. It also presents a challenge in discriminating...
Earth Walls: Making the Right Choice
Earth walls are retaining walls where the ground assumes a load-bearing role. These walls either support compacted earth (embankment-type reinforced compacted earth walls such as Doublewal...
New Support for Pin-Hanger Bridges
To promote safety of their bridges, many state highway departments are considering ways to add auxiliary support to existing pin-hanger bridges. The Pennsylvania DOT and its open-end consultant...
Design of Large Capacity Coal Silos for Service Life
Design and construction of Large Capacity Coal Silos for service life requires a careful consideration of the silo configuration as well as the material handling system. This paper presents...
Structural Renovation of Tall Chimneys
This paper describes several tall chimney projects where major renovations were performed to the linings which required complete structural analysis of the existing chimney and foundation....
Improved Corrosion Protection for Flue Gas Systems Utilizing a Dual Liner Concept
A unique system of corrosion resistant materials has shown excellent performance and durability in flue gas systems for fossil plants, cogeneration plants, waste incinerators and waste-to-energy...
Designing for Corrosion Control
This presentation will discuss designing from several aspects: a. Designing of the item to lessen the affects of corrosion. b. Selection of non-corrosive materials in the designing process...
Anchoring?A New Generation
During the time period of NRC Bulletin 79-02, and certainly afterwards, the use and application of wedge type anchors in Nuclear Power Plants took on a new perspective. The data gathered...
Introduction to Structural and Mechanical Failure Modes for Nuclear Power Facilities
The three papers presented in this section discuss the types of information (i.e., dynamic tests, earthquake experience and analytical data) which are used in predicting the capacity of...
Containment Capacity and Failure Modes Beyond Design Basis Conditions
Analytical and experimental studies have shown that containments can at least sustain two to three times design pressures. Under the severe accident overpressure loading, experimental...
Fly Ash Grouts for Subsidence Control
A laboratory investigation was undertaken to examine procedures for evaluating candidate grouts and to develop quality grouts for use in abandoned mines. The objective of this grout application...
Properties and Environmental Impact of Stabilized Fly Ash
This paper summarizes the results of two research studies aimed at evaluating the properties and possible environmental effects of bituminous and lignite coal based fly ashes stabilized...
Return to search