Hydraulic Fill Dam Made Earthquake Resistant
San Pablo Dam, near the San Andreas fault, constructed in 1919-21 by hydraulic fill methods, was found to be susceptible in places to liquefaction under seismic loading. The dam has been...

Bridging Twin Ports
The Major Richard I. Bong Memorial Bridge, part of U. S. Highway 2, connects harbors at Duluth, Minn. and Superior, Wisc. The new highway link was designed to relieve congestion on nearby...

Construction-Induced Dynamic Pressure and Corresponding Impact Factors for Pipelines
The Bureau of Reclamation, U. S. Department of the Interior, conducted a study which measured pressure exerted by construction scrapers on a rigid, buried, instrumented concrete slab....

Effects of Vehicles on Buried, High-Pressure Pipe
The mechanical effects of selected types of traffic on buried, high-pressure steel pipe are examined. Particularly considered is a section of the Colorado Interstate Gas (CIG) pipeline...

Effect of Shallow Trench Construction on Cast Iron Pipelines
This paper summarizes the results of three-dimensional finite element analyses to evaluate the strains and displacements sustained by 4, 6, and 8-in. (100, 150, and 200 mm)-diameter cast...

Influence of Depth-of-Cover on Pipe-Soil Interaction
A major research effort was undertaken to study the structural behavior of a natural gas pipeline under several critical service conditions. The program included a field test site near...

An Instrumented Soil-Pipe System: Automated Data Acquisition and Management
A 16-in. natural gas pipeline near Racine, Wisconsin, had been in service for some 30 years. In 1982 road widening operations on a line parallel with the pipe resulted in a heavily trafficked...

Metal and Plastic Pipelines: Design and Construction Aspects
This paper discusses design and construction aspects of four cross-country pipelines that were built in central Alberta, Canada during 1982-1983. The first two pipelines, carrying different...

Clay Pipe Installation?Advances in Load Factors
This report presents an evaluation of traditional load factor values for clay pipe and the development of a new bedding system which gives a higher load factor. Tests demonstrate that...

The Evolution of Jointing Vitrified Clay Pipe
Advances made in the jointing of vitrified clay pipe during the last half century, illustrate the concern of the clay pipe industry to provide top quality jointing methods. Early 19th...

Sewer Construction Inspection and Testing
Sewer construction testing is the final portion of the team effort that started with the goal of meeting the requirement for a sewer system for the protection of health and environment....

Investigations into the Structural Performance of Clay Pipes
Over the past 8 years, the Clay Pipe Development Association (CPDA) has commissioned non-destructive physical testing of vitrified clay pipelines. The diameters of the pipes have varied...

Unique Installation Methods for Large Interceptor in Poor Soil Conditions
The construction of approximately 1. 5 miles of a major sewer interceptor in downtown Boston encountered some unique construction challenges. The entire route required dewatering during...

Failure of a Large Reinforced Concrete Pipeline
This paper describes the damage that occurred when a landslide overloaded an 11 ft diameter reinforced concrete pipeline. The 8 ft lengths of pipe, each of 11. 5-in. wall thickness, were...

SPIDA: An Analysis and Design System for Buried Concrete Pipe
The paper presents a description of a new computerized direct design method for buried concrete pipe named SPIDA (Soil-Pipe Interaction Design and Analysis). Also the technical basis and...

Experiences in Concrete Pipeline Construction in Ontario 158-1985
The paper discusses the title subject in terms of concrete pipe fabrication methods and plants, pipe jointing and jointing materials, and construction experiences in the Province of Ontario,...

Simplified Stress and Deformation Analysis for Pipeline Construction
This paper discusses the strength and deformation behavior of flexible steel pipes during pipeline construction. Some possible simple and quick solutions to these special design and construction...

Longitudinal Prestressed Piping for District Heating
The design of recently installed hot water district heating systems in the United States is based on similar systems developed in Europe. Longitudinal prestressing is used in the design...

Modeling Failure Probability of Underground Pipes
Factors influencing the performance of underground gas pipes are identified through a literature search and contacts with several utility companies. These factors are categorized as (i),...

Stress-Intensification Factor and Flexibility Factor in Seismic Analysis of Continuous Buried Pipelines
The topics of intensified stresses and increased flexibility in pipe bends subjected to bending loads are discussed in this paper. Also discussed are dynamic strain compatibility between...

 

 

 

 

Return to search