Impact of Dynamic Loading on Bio-Phosphorus Removal
The ability of bench-scale activated sludge biological phosphorus removal systems to produce effluents with consistently low phosphorus concentrations was influenced by influent TOC/COD...
Structural Safety Studies
Structural engineers are most concerned with the safety aspect of structures. The primary objective of structural engineers is to produce structures which are satisfactory in meeting certain...
Drilled Piers and Caissons II
Drilled piers or caissons, also called drilled shafts or bored piles, have long been a very cost effective foundation solution for many soil profile and load situations. A distinct advantage...
Annual and Seasonal Variations of Phosphorus Loads in the Okanagan River
Results of monitoring of phosphorus loads in the Okanagan River channel linking Okanagan, Skaha and Osoyoos Lakes are described. The southern Okanagan basin is the area where major changes...
Agricultural Nonpoint Source Control Program for Lake Erie
Congress mandated (PL 92-500, Sec. 108d and 108e) that the U. S. Army Corps of Engineers design and develop a program for the rehabilitation and environmental repair of Lake Erie. The...
A Carrying Capacity Study of Hatteras Island
This article summarizes a study done of Hatteras Island, North Carolina, a largely undeveloped and natural barrier island. 'Carrying capacity' means the ability...
The Statistics of Storm-Induced Sediment Resuspension
The passage of a storm increases the wind stress applied to the sea surface. This surface stress is partially dissipated as it is transmitted through the water column. Some fraction of...
Staggered Truss Adapted to High Rise
The 34-floor Nashville Convention Center Hotel required a structural system that would overcome the tendency to vibrate in the wind. The solution was a modified staggered frame truss,...
Hydraulic Fill Dam Made Earthquake Resistant
San Pablo Dam, near the San Andreas fault, constructed in 1919-21 by hydraulic fill methods, was found to be susceptible in places to liquefaction under seismic loading. The dam has been...
Tapping Deep Water Resources
Lena is the first commercial guyed tower. Its jacket is the longest ever fabricated, loaded out and launched in one piece. Lena stands in 1,000 ft deep water and has a three-level oil...
Project Mixes Oil and Water
The Prudhoe Bay Seawater Treatment Plant was nominated for an OCEA award, for its potential to coax from Alaska's north slope 1 billion barrels of oil which otherwise would...
Clay Pipe Installation?Advances in Load Factors
This report presents an evaluation of traditional load factor values for clay pipe and the development of a new bedding system which gives a higher load factor. Tests demonstrate that...
Failure of a Large Reinforced Concrete Pipeline
This paper describes the damage that occurred when a landslide overloaded an 11 ft diameter reinforced concrete pipeline. The 8 ft lengths of pipe, each of 11. 5-in. wall thickness, were...
Modeling Failure Probability of Underground Pipes
Factors influencing the performance of underground gas pipes are identified through a literature search and contacts with several utility companies. These factors are categorized as (i),...
Stress-Intensification Factor and Flexibility Factor in Seismic Analysis of Continuous Buried Pipelines
The topics of intensified stresses and increased flexibility in pipe bends subjected to bending loads are discussed in this paper. Also discussed are dynamic strain compatibility between...
Long Term Deflection of Buried Plastic Sewer Pipes
During the 70's and the early 80's a research program has been carried out in Sweden regarding the long term behaviour of buried plastic pipes. The program has...
Dynamics of Buried Pipelines
Forced motion of pipelines due to stationary or moving loads is studied. The pipe is modeled as an elastic shell in an elastic (or viscoelastic) medium. The interaction of the shell and...
Earth Pressure and Surface Load Effects on Buried Pipelines
Rational techniques for analyzing earth pressure and surface load effects, based on finite element analysis methods, have been developed and applied extensively to the design of buried...
Long Term Testing of Centrifugally Cast Glass Fibre Reinforced Plastic Pipes (RIRP)
The paper discusses testing of pipe manufactured by centrifugal molding. The tests included external load tests, internal load, hydrostatic internal pressure, and cyclic internal pressure....
Characterization of Soil Arching Above Buried Conduits
Conventional ways of assessing the effects of soil arching over buried conduits were examined by means of finite element analyses. It was found that neither of the conventional soil arching...
Return to search