Blast-Damaged Concrete Structures in Beirut
This paper describes the effect of blasting loads on structural members. It identifies predominant structural systems in war-damaged zones of Beirut and to explain typical damage mechanisms....
Fluid Viscous Damper for Improving the Earthquake Resistance of Buildings
Experimental results are presented which demonstrate that the use of fluid dampers as add-on devices in moment resisting frames substantially increases damping and reduces seismic story...
Viscoelastic Dampers for Seismic Pounding Mitigation
A hysteretic model for viscoelastic (VE) damper is explained. The model accurately accounts for the effects of excitation frequency as well as temperature of the damper. Benefit of using...
Seismic Isolation Retrofit of the State of California Justice Building
The State of California Justice Building, located at 350 McAllister Street, San Francisco, is the first building to be selected by the State of California for retrofit using seismic (base)...
Evaluation of Seismic Isolation Schemes for a Historic Building
The U.S. Court of Appeals Ninth District building originally completed in 1905 with an expansion in 1933, suffered damage during the 1989 Loma Prieta earthquake. The building is currently...
Hybrid Control of Sliding Isolated Structures
The seismic response of buildings and bridges can be improved by isolating the structure with a seismic sliding bearings. Specialized passive devices are commonly used to complement these...
Investigation of Full-Scale Performance of Structures?Research Potentials
It is well known that actual, or true, behavior of completed structures does not necessarily conform to often simplified analysis predictions. This may be due to any of several reasons...
Seismic Strengthening for Structures in Regions of Low Seismicity
Most existing structures were not designed to today's seismic codes and standards, and in fact in low seismicity regions codes did not require seismic design until recently....
Conceptual Design of a Monitoring System for Maglev Guideways
The state-of-the-art in nondestructive testing (NDT) technology has advanced significantly over the past fifteen years and has reached a stage where continuous monitoring of structures...
A Shear Transfer Model for Floor-To-Wall Connections in Concrete Masonry Structures
Based upon experiments conducted at the Univ of California, San Diego (UCSD) on floor-to-wall connections in concrete masonry structures, a constitutive model was developed for the overall...
Design of Connections in Wood Structures: LRFD vs. ASD
This paper provides a comparison of connection design capacities using load and resistance factor design (LRFD) procedures and allowable stress design (ASD) procedures....
Wood Diaphragm Design Capacities in LRFD Format
Wood diaphragms (horizontal and vertical) have performed well in resisting and transferring lateral forces imposed by major wind and seismic events. Resilient (ductile) behavior of wood...
Serviceability Reliability Analysis of Wood Beams
The effect of creep deformations on the serviceability reliability of single wood beams is investigated. Using stochastic load models and a time-dependent stress-strain relationship, the...
A Prototype Expert System for Rapid Visual Screening of Seismically Hazardous Buildings in California
A rapid visual screening expert system, California Rapid Building Seismic Evaluation Expert, was developed to enable efficient and effective identification of seismically hazardous buildings...
Flexural and Shear Behavior of Combined Concrete and Graphite Epoxy Beams
An experimental and analytical study of six graphite composite beams are presented. Four of the beams incorporated a reinforced concrete slab. The composite action and the effect of concrete...
Seismic Resistance of Steel Fiber Reinforced Concrete Beam-Column Joints
This paper discusses the advantages of using steel fibers in seismic resistant beam-column connections. First, the effects of fibers on the various aspects of behavior of concrete are...
In-Situ Determination of the Compressive Stress-Strain Relationship of Multi-Wythe Brick Masonry
In-situ stress-strain relationships of existing multi-wythe brick masonry have been determined by introducing flatjacks into sawcuts made in the exterior wythe of the multi-wythe masonry....
Teaching Structural Engineering in Year 2000
The paper addresses the need for changes in engineering education in order to keep pace with the changes that have and will continue to take place in the workplace. Over the past 40 years...
Interfacing Academia and the Practicing Profession
The paper presents a discussion of current topics and instructional methods in structural engineering in the United States. Following a review of typical subject matter in analysis and...
Risk-Based Methodology for Seismic Rehabilitation of Earth Dams
A methodology for seismic risk analysis of earth dams is described. The procedure utilizes seismological and geotechnical inputs together with the associated uncertainties and provides...
Return to search