ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Furrow Irrigation Education
A furrow irrigation simulation computer model based on the volume-balance method is described. The model is used to develop information on furrow system performance that can be used in...

Optimal Commands in Border Irrigation Systems
Optimal command areas and level border irrigation design parameters are obtained for a given available seasonal water supply using a dynamic programming (DP) optimization approach. The...

An Irrigation Allocation Planning Model
An irrigation allocation model using multiperiod linear programming was developed to recommend canal water allocation among different irrigated fields to maximize net annual benefits for...

A Flexible Expert System Based Typology of Irrigation System Types
This paper describes an approach developed to classify irrigation systems into categories. It discusses the general problem of developing a typology of irrigation systems and proposes...

Development of a Hydrological Database for PROSIM?A Water Rights-Based Operational Simulation Model of the Provo River
The development of a hydrological database for a computer model of the hydrology, water rights, and operations of the Provo and Weber rivers is described. The model uses all pertinent...

BASIN 2.0 for the Design of Level-Basin Irrigation Systems
The purpose of this paper is to present a computer program for the hydraulic design of level-basin irrigation systems. The first of three design modes provides design based on the advance...

CPIVOT v 2.0 Center Pivot Analysis and Design Software
A micro-computer based software package is presented which can be used for hydraulic design and/or analysis of center pivot irrigation systems. The software is written in C and requires...

Estimating ET Using Turbulent Coherent Structures
Two methods for estimating sensible heat flux to use in energy balance equations for computing crop evapotranspiration are discussed. The methods use high frequency temperature measurements...

Comparing Bowen Ratio-Energy Balance Systems for Measuring ET
Two Bowen ratio-energy balance (BREB) systems for measuring evapotranspiration (ET) under wet and dry conditions were compared. The study sites were an irrigated grass sod near Kimberly,...

Growing Season Evapotranspiration and Crop Coefficient
The Bowen ratio-energy balance (BREB) method was used to continuously estimate 20-minute actual evapotranspiration (ET_a) in the middle of a 36-ha...

Hourly Reference Evapotranspiration by Bowen Ratio and Penman Methods
Hourly and daily reference evapotranspiration (ETo) computed from Bowen ratio energy balance (BREB) measurements were compared with ETo estimated from the hourly Penman equation (ETP)....

Revision of Oregon Crop Water Use and Irrigation Requirements
A project to revise the crop water use estimates and irrigation requirements for the state at Oregon is described. The FAO modified Blaney-Criddle method was applied in this project since...

Streamflow Depletions and Water Transfers in Idaho
In the state of Idaho, streamflow depletions are quantified utilizing parameters of rate of flow, total volume diverted, and volume consumptively used. This paper summarizes the engineering...

Streamflow Depletions Considered in Water Transfers
In the State of Colorado, streamflow depletions are defined as that amount of water diverted to beneficial use minus return flows to the stream system. This paper summarizes the engineering...

Evaluating the Facts in Water Right Changes
Under the western system of appropriation water rights may be separated from the land and the time, type and place of use changed. Such changes are governed by the principle that there...

Soil Bulk Density Sampling for Neutron Gauge Calibration
The ASCE Task Committee on Neutron Gauge Calibration met in Logan, Utah in July 1992 to investigate the various methods of soil sampling, installation of access tubes, effect of various...

Measuring Soil Bulk Density Profiles with a Single Probe Gamma Density Gauge
Calibrating neutron depth gauges for measuring soil water content profiles requires soil bulk density data. In this study, the feasibility of using a single probe gamma density gauge to...

Error Analysis of Bulk Density Measurements for Neutron Moisture Gauge Calibration
Six bulk density sampling methods were evaluated for use in neutron gauge calibration. All six methods provided estimates of bulk density which were generally within 5% of bulk density...

Performance Factors of Neutron Moisture Probes Related to Position of Source on Detector
The performances of two commercially available neutron moisture probes with different source-detector placement were evaluated. The probes were the Troxler with the neutron source placed...

Neutron Gauge Calibration Comparison of Methods
Several methods for obtaining soil samples for determining soil water content were used for field calibration of neutron gauges. This paper compares the results of calibration curves obtained...

 

 

 

 

Return to search