Security of Unattended Pipeline Stations
The ultimate purpose of a security system is to maintain equipment and service in a normal operating condition or to restore the equipment and service to normal operating condition as...
Economics of Groundwater-Pumping Level Statutes
Pumping from one well may lower the water table in another to the point where pumping from it becomes unfeasible. Problems exist in allocating the increased costs of pumping caused by...
Ground Water Economics in the San Joaquin Valley
Ground water pumping in the San Joaquin Valley to supplement surface water supplies has increased from about 200 thousand acre-feet per year at the beginning of this century to nine million...
Drip Irrigated Cotton: Economics and Water Savings
Groundwater withdrawals for cotton production in the arid Southwest account for about 15 percent of all groundwater withdrawals. In Arizona, cotton's proportion of groundwater...
The Present Status of Application of the Plastic Concepts in Structural Design
The different approaches of recognizing plastic behavior in the design of steel structures are reviewed and the design requirements that assure successful utilization of this behavior...
Computer-Automated Limit-States-Design of Steel Frameworks
The paper concerns the computer-automated synthesis of minimum-weight planar steel frameworks. For any number of applied loading cases, the design of the structure may be constrained by...
Reliability-Based LRFD for Transmission Structures
A simple reliability-based Load and Resistance Factor Design (LRFD) method is proposed for the structural design of electric transmission lines. With the proposed method, the designer...
Plastic Design Requirements of the AISC Proposed LRFD Specification
The American Institute of Steel Construction proposed LRFD Specification (1) has recently completed a one year period of trial use and review. This paper discusses the background of the...
Specialization Vs. Diversification ? Relevant Considerations
The health, well-being, and growth of consulting engineering firms demand a successful strategy covering specialization vs. diversification. A discussion of the pros and cons and some...
Limiting Tip and Side Resistance: Fact or Fallacy?
The tip and side resistances of deep foundations do not reach a limit at a critical depth; instead, they increase with depth. For the tip, the rate of increase decreases with depth. For...
Residual Stresses in Piles and the Wave Equation
A data base of 18 vertical load tests on driven piles in sand is presented. On average the residual point load was 56% of the measured point load and the residual friction load 19% of...
Compression Load Tests on Concrete Piles in Alluvium
A series of tests was accomplished during the design phase for the West Seattle Freeway Bridge Replacement project. The results of instrumented compression load tests in alluvial deposits...
Evaluation of P-Y Relationships in Cohesive Soils
The practice of analyzing laterally loaded driven and bored piles often requires modeling of soil response in terms of uncoupled, non-linear unit load transfer functions. These functions,...
Pile Caps Subjected to Lateral Loads
This paper reviews current pile cap design practices and presents results of tests on two pile caps with different reinforcement locations. Lateral load tests performed on two pile cap...
A Structural Engineering Perspective for Drilled Shafts
This commentary is an attempt to close the gap between the Building Code Requirements for Reinforced Concrete (ACE 318-83) and the design of drilled shafts. The context of design includes...
ASCE Drilled Shaft Standard: University Perspective
A critique is presented of the proposed ASCE standard on drilled shafts. Areas where major work is necessary relate primarily to the shaft design sections, establishment of loads, and...
Influence of Connection Behavior on Steel Frame Designs at Factored Loads
This paper illustrates how interactive computer graphics, when interfaced with nonlinear inelastic frame analysis programs, can provide a powerful tool for design of semi-rigid frames...
Selecting an Economical Water Main Rehab
Many miles of aging water mains exist with carrying capacities that are less than half of what they were when new. Engineers must, therefore, stretch every dollar to eliminate deposits...
Management Strategy for Disposal of Dredged Material
The diversity of disposal alternatives and techniques for management of contaminated dredged material requires the development of an overall management strategy for disposal. The selection...
Abrasion Resistance of Polyethylene Dredge Pipe
In recent years there has been a slow but steady increase in the number of dredges using high density polyethylene (HDPE) pipe in discharge lines. HDPE's increased popularity...
Return to search