Soil Bulk Density Sampling for Neutron Gauge Calibration
The ASCE Task Committee on Neutron Gauge Calibration met in Logan, Utah in July 1992 to investigate the various methods of soil sampling, installation of access tubes, effect of various...
Measuring Soil Bulk Density Profiles with a Single Probe Gamma Density Gauge
Calibrating neutron depth gauges for measuring soil water content profiles requires soil bulk density data. In this study, the feasibility of using a single probe gamma density gauge to...
Error Analysis of Bulk Density Measurements for Neutron Moisture Gauge Calibration
Six bulk density sampling methods were evaluated for use in neutron gauge calibration. All six methods provided estimates of bulk density which were generally within 5% of bulk density...
Performance Factors of Neutron Moisture Probes Related to Position of Source on Detector
The performances of two commercially available neutron moisture probes with different source-detector placement were evaluated. The probes were the Troxler with the neutron source placed...
Neutron Gauge Calibration Comparison of Methods
Several methods for obtaining soil samples for determining soil water content were used for field calibration of neutron gauges. This paper compares the results of calibration curves obtained...
Effect of Moisture and Bulk Density Sampling on Neutron Moisture Gauge Calibration
Three moisture and bulk density sampling methods were evaluated for use in neutron gauge calibration. Each of the methods was comprised of a single core or portions of a core taken during...
Soil Moisture Monitoring Using a Portable Capacitance Probe
Accurate monitoring of soil moisture has long been in integral part of a successful agricultural management system. Water has increasingly become a valuable and much sought after natural...
Water Penetration Manual for California Soils
Slow water penetration in irrigated soils is a complex problem of major importance in California's $18 billion agricultural industry. The Kearney Foundation of Soil Science chose to work...
Evapotranspiration of Dry Beans with Drip Irrigation
Information about the effect of irrigation on dry bean production in the Southwestern Colorado is very limited. The primary objective of this study is to establish a crop water use (ET)...
Getting Along: The Geotech and the CM
The opinions of geotechnical engineers are usually respected within a consulting firm, but when such a specialist gets out in the field, he or she is seen as merely part of the backup...
Lead is a Four-Letter Word
New regulations and strict enforcement make it difficult and expensive to remove lead-laden coatings from steel structures. Lead-based primers and paints are not considered hazardous as...
A Solid Waste Solution
Burgeoning growth and diminishing landfill capacity have been propelling Broward County, Fla. toward a solid-waste crisis. The county, located along Florida's southeastern...
Watershed Erosion
Scientific agricultural planning requires knowledge of the relations between soil and water that cause soil loss, and of the procedure to reduce such losses on cropland. This paper presents...
The Coyote Dam Outlet Works Replacement Project: Hazard Reduction
The Santa Clara Valley Water District's Coyote Dam faced three major concerns: siltation of the existing outlet; a fault that crosses the existing outlet pipe; and the dam toe and the...
Hydraulic Performance of Culvert End Sections Designed for Collision Safety
A type of end section for pipe culverts that was designed for collision safety has some favorable hydraulic characteristics. These safety end sections are long and narrow with large steel...
Compacted Spillway
The compacted spillway (CSW) refers to a spillway accompanied by jets located on its face to dissipate the excess energy. The (CSW) has a standard ogee profile with three jets located...
Equations to Predict Critical Submergence at Horizontal Hydraulic Intakes
The formation of free surface vortices at hydraulic intakes can disrupt operation and damage machinery. It is also a serious safety concern. Theoretical investigations and laboratory tests...
Hydraulic Analysis of the McCook Outlet Manifold
A 1:40-scale model of the proposed McCook Outlet Manifold was tested at the U.S. Army Engineer Waterways Experiment Station (WES). Subsequently, flow conditions in the manifold were calculated...
Total Sediment Loads of Tropical Rivers
Unmeasured and total sediment discharges were computed for 107 sets of data from the Amazon and Orinoco Rivers and their major tributaries. Unmeasured loads were generally small except...
Sedimentation and Flood Protection for the Lower Yellow River
The Lower Yellow River is known for its disastrous floods in the past. After 4 decades without major floodings, rapid economic and population growths along the River have drew concerns...
Return to search